Subject: [PATCH V4 2/2] thermal: imx: add i.MX7 thermal sensor support

From: [email-masked] (Leonard Crestez)
Date: Wed, 28 Feb 2018 19:25:31 +0200

On Sat, 2018-02-24 at 16:02 +0800, Anson Huang wrote:
> This patch adds i.MX7 thermal sensor support, most
> of the i.MX7 thermal sensor functions are same with
> i.MX6 except the registers offset/layout, so we move
> those registers offset/layout definitions to soc data
> structure.
> 
> i.MX7 uses single calibration data @25C, the calibration
> data is located at OCOTP offset 0x4F0, bit[17:9], the
> formula is as below:
> 
> Tmeas = (Nmeas - n1) + 25; n1 is the fuse value for 25C.
> 
> Signed-off-by: Anson Huang <[email-masked]>
> Signed-off-by: Bai Ping <[email-masked]>

On imx7d (also 6sx and 6ul) OCOTP read will hang silently if the ocotp
clk is not enabled. For example this can happen if imx_thermal is built
as a module or probes after unused clocks are disabled.

This driver has support for reading ocotp values through the ocotp
nvmem driver (which handles clks properly). Since imx7d is a new
compatible string for upstream maybe you could just make new-style
bindings mandatory and drop the changes to?imx_init_from_tempmon_data?

See?commit 2067b757e972 ("ARM: dts: imx6ul: Add imx6ul-tempmon")

--
Regards,
Leonard