Subject: [PATCH 2/3] ARM: OMAP2+: Add new bindings for OMAP

From: [email-masked] (Tony Lindgren)
Date: Wed, 21 Aug 2013 05:23:28 -0700

* Rajendra Nayak <[email-masked]> [130821 02:29]:
> On Wednesday 21 August 2013 02:23 PM, Tony Lindgren wrote:
> > 
> > Or you could also have various bus specific bindings for the ocp
> > with lists of phandles?
> > 
> > ocp {
> > 	reg = <...>;
> > 	interrupts = <...>;
> > 	ti,reset-on-init = <&module1, &module2>;
> > 	...
> > };
> > 
> > Or something similar.
> 
> The only problem I see with this is that some of these modules could be
> board specific ones and need to be part of the board dts files, like
> some boards which have PMIC power switch hooked up to some gpio etc.
> So there could be some SoC specific modules (like emif/gpmc on OMAPs)
> and some which depend on how the boards are designed.

You can still override the ocp entry in the board specific .dts file.
Would probably be a lot easier than to override each module separately
in the board specific .dts file.

Regards,

Tony