Subject: [RFC 1/2] mfd: qcom-rpm: Expose sleep state resources to clients

From: [email-masked] (Bjorn Andersson)
Date: Tue, 11 Nov 2014 10:33:21 -0800

On Tue 11 Nov 04:04 PST 2014, Lee Jones wrote:

> On Mon, 10 Nov 2014, Bjorn Andersson wrote:
> 
> > Resources exposed from the RPM have an "active state" that is used during
> > normal operations and a "sleep state" that is used for HW assisted sleep
> > modes. Expose this in the api to let client drivers set the "sleep
> > state" as well.
> 
> I assume you have users lined up which will request a sleeping state?
> 

All users of this interface (regulators, clocks and bus scaling) will have to
be able to specify this.

[..]
> > @@ -359,8 +361,7 @@ int qcom_rpm_write(struct qcom_rpm *rpm, int resource, u32 *buf, size_t count)
> >  			       RPM_CTRL_REG(rpm, RPM_REQ_SELECT + i));
> >  	}
> >  
> > -	writel_relaxed(RPM_ACTIVE_STATE,
> > -		       RPM_CTRL_REG(rpm, RPM_REQUEST_CONTEXT));
> > +	writel_relaxed(BIT(state), RPM_CTRL_REG(rpm, RPM_REQUEST_CONTEXT));
> 
> How are the state bits organised?
> 

BIT(0) is active mode, BIT(1) is sleep mode, as specified below. I could add
some sanity checking here if you would like to.

[..]
> > diff --git a/include/linux/mfd/qcom_rpm.h b/include/linux/mfd/qcom_rpm.h
> > index a60798d..f0e70b2 100644
> > --- a/include/linux/mfd/qcom_rpm.h
> > +++ b/include/linux/mfd/qcom_rpm.h
> > +#define RPM_ACTIVE_STATE	0
> > +#define RPM_SLEEP_STATE		1

Regards,
Bjorn