Subject: [PATCH v3 3/3] mtd: s3c2410: parse the device configuration from OF node

From: [email-masked] (Sergio Prado)
Date: Mon, 24 Oct 2016 16:47:38 -0200

On Mon, Oct 24, 2016 at 03:02:01PM +0200, Boris Brezillon wrote:
> > +static int s3c2410_nand_setup_data_interface(struct mtd_info *mtd,
> > +					     const struct nand_data_interface *conf,
> > +					     bool check_only)
> > +{
> > +	struct s3c2410_nand_info *info = s3c2410_nand_mtd_toinfo(mtd);
> > +	struct s3c2410_platform_nand *pdata = info->platform;
> > +	const struct nand_sdr_timings *timings;
> > +	int tacls;
> > +
> > +	timings = nand_get_sdr_timings(conf);
> > +	if (IS_ERR(timings))
> > +		return -ENOTSUPP;
> > +
> > +	tacls = timings->tCLS_min - timings->tWP_min;
> > +	if (tacls < 0)
> > +		tacls = 0;
> > +
> > +	pdata->tacls  = DIV_ROUND_UP(tacls, 1000);
> > +	pdata->twrph0 = DIV_ROUND_UP(timings->tWP_min, 1000);
> > +	pdata->twrph1 = DIV_ROUND_UP(timings->tCLH_min, 1000);
> 
> You seem to only apply the timings in s3c2410_nand_setrate(), which is
> only called at probe time or on a cpufreq even, but the core can change
> timings at runtime (this is what happens each time you reset the chip).
> 
> To support that you have 2 options:
>  - apply the timings in ->select_chip()
>  - apply the timings here

Right. As far as I understood, ->setup_data_interface() will be called
when MTD core change timings at runtime, so it is enough to apply the
timings in the end of ->setup_data_interface()?

Thanks,

Sergio Prado