Subject: [PATCH 2/2] arm64: dts: ti: k3-am65: Add pinctrl regions

From: [email-masked] (Tony Lindgren)
Date: Thu, 8 Nov 2018 07:13:56 -0800

* Nishanth Menon <[email-masked]> [181108 13:48]:
> On 16:56-20181108, Vignesh R wrote:
> > diff --git a/arch/arm64/boot/dts/ti/k3-am65.dtsi b/arch/arm64/boot/dts/ti/k3-am65.dtsi
> > index 3d4bf369d030..873dca1d0813 100644
> > --- a/arch/arm64/boot/dts/ti/k3-am65.dtsi
> > +++ b/arch/arm64/boot/dts/ti/k3-am65.dtsi
> > @@ -8,6 +8,7 @@
> >  #include <dt-bindings/gpio/gpio.h>
> >  #include <dt-bindings/interrupt-controller/irq.h>
> >  #include <dt-bindings/interrupt-controller/arm-gic.h>
> > +#include <dt-bindings/pinctrl/k3-am65.h>
> >  
> >  / {
> >  	model = "Texas Instruments K3 AM654 SoC";
> > -- 
> > 2.19.1
> > 
> 
> Where is this used? Could we mux the uart console that we are using?
> will be good to see an example of usage.

Yes please.

And please add the SoC specific macro for the pins in a format
that makes the pinconf and pinmux options separate parameters
for the macro where the usage becomes something like:

AM65X_IOPAD(0x1234, PIN_INPUT_PULLUP, 0)

The above  0 is just the mux mode number in the example.
So no more need to use MUX_MODE0 define to redefine a number
when set up that way :)

This will allow us to eventually take advantage of the
#pinctrl-cells = <2>  and not have to change all the dts files
and just change the macro.

I also added Linus Walleij to Cc as this might interest him
also.

Regards,

Tony