Subject: Re: [PATCH v3 2/9] dt-bindings: i2c: add bindings for i2c analog and digital filter

From: Wolfram Sang <[email-masked]>
Date: Sat, 31 Aug 2019 13:39:09 +0200

On Tue, Jul 09, 2019 at 01:19:33PM +0000, [email-masked] wrote:
> From: Eugen Hristev <[email-masked]>
> 
> Some i2c controllers have a built-in digital or analog filter.
> This is specifically required depending on the hardware PCB/board.
> Some controllers also allow specifying the maximum width of the
> spikes that can be filtered. The width length can be specified in nanoseconds.
> 
> Signed-off-by: Eugen Hristev <[email-masked]>
> ---
>  Documentation/devicetree/bindings/i2c/i2c.txt | 11 +++++++++++
>  1 file changed, 11 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/i2c/i2c.txt b/Documentation/devicetree/bindings/i2c/i2c.txt
> index 44efafd..a2d31aa 100644
> --- a/Documentation/devicetree/bindings/i2c/i2c.txt
> +++ b/Documentation/devicetree/bindings/i2c/i2c.txt
> @@ -55,6 +55,17 @@ wants to support one of the below features, it should adapt the bindings below.
>  	Number of nanoseconds the SDA signal takes to fall; t(f) in the I2C
>  	specification.
>  
> +- i2c-ana-filter
> +	Enable analog filter for i2c lines.
> +
> +- i2c-dig-filter
> +	Enable digital filter for i2c lines.

Would you be OK with writing out 'analog' and 'digital' in full form?
The abrreviation doesn't save us much, I'd think, and I didn't find
similar wording in existing bindings.

> +
> +- i2c-filter-width-ns
> +	Width of spikes which can be filtered by either digital or analog
> +	filters (i2c-ana-filtr or i2c-dig-filtr). This width is specified
> +	in nanoseconds.
> +
>  - interrupts
>  	interrupts used by the device.
>  
> -- 
> 2.7.4
> 
_______________________________________________
linux-arm-kernel mailing list
[email-masked]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel