Subject: Re: [PATCH v3 6/8] ARM: dts: omap36xx: using OPP1G needs to control the abb_ldo

From: Tony Lindgren <[email-masked]>
Date: Mon, 16 Sep 2019 09:25:53 -0700

* H. Nikolaus Schaller <[email-masked]> [190911 17:48]:
> See DM3730,DM275 data sheet (SPRS685B) footnote (6) in Table 4-19
> which says that ABB must be switched to FBB mode when using the
> OPP1G.
> 
> The LOD definition abb_mpu_iva already exists so that we need
> to add plumbing for vbb-supply = <&abb_mpu_iva>
> and define two voltage vectors for each OPP so that the abb LDO
> is also updated by the ti-cpufreq driver.
> 
> We also must switch the ti_cpufreq_soc_data to multi_regulator.
> 
> Note: reading out the abb reglator voltage to verify that
> it does do transitions can be done by
> 
> cat /sys/devices/platform/68000000.ocp/483072f0.regulator-abb-mpu/regulator/regulator.*/microvolts
> 
> Likewise, read the twl4030 provided VDD voltage by
> 
> cat /sys/devices/platform/68000000.ocp/48070000.i2c/i2c-0/0-0048/48070000.i2c:twl@48:regulator-vdd1/regulator/regulator.*/microvolts
> 
> Note: to check if the ABB FBB is enabled/disabled, check
> registers
> 
> PRM_LDO_ABB_CTRL 0x483072F4 bit 3:0 1=bypass 5=FBB
> PRM_LDO_ABB_SETUP 0x483072F0 0x00=bypass 0x11=FBB
> 
> e.g.
> 
> /dev/mem opened.
> Memory mapped at address 0xb6fe4000.
> Value at address 0x483072F4 (0xb6fe42f4): 0x3205
> /dev/mem opened.
> Memory mapped at address 0xb6f89000.
> Value at address 0x483072F4 (0xb6f892f4): 0x3201
> 
> Note: omap34xx and am3517 have/need no comparable LDO
> or mechanism.

Acked-by: Tony Lindgren <[email-masked]>

_______________________________________________
linux-arm-kernel mailing list
[email-masked]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel