Subject: [PATCH v2 1/4] spi: make spi-max-frequency optional

From: Chuanhong Guo <[email-masked]>
Date: Fri, 28 Feb 2020 12:36:33 +0800

We only need a spi-max-frequency when we specifically request a
spi frequency lower than the max speed of spi host.
This property is already documented as optional property and current
host drivers are implemented to operate at highest speed possible
when spi->max_speed_hz is 0.
This patch makes spi-max-frequency an optional property so that
we could just omit it to use max controller speed.

Signed-off-by: Chuanhong Guo <[email-masked]>
---
Change since v1:
 new commit

 drivers/spi/spi.c | 9 ++-------
 1 file changed, 2 insertions(+), 7 deletions(-)

diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
index 38b4c78df506..c0c55dc79972 100644
--- a/drivers/spi/spi.c
+++ b/drivers/spi/spi.c
@@ -1955,13 +1955,8 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi,
 		spi->mode |= SPI_CS_HIGH;
 
 	/* Device speed */
-	rc = of_property_read_u32(nc, "spi-max-frequency", &value);
-	if (rc) {
-		dev_err(&ctlr->dev,
-			"%pOF has no valid 'spi-max-frequency' property (%d)\n", nc, rc);
-		return rc;
-	}
-	spi->max_speed_hz = value;
+	if (!of_property_read_u32(nc, "spi-max-frequency", &value))
+		spi->max_speed_hz = value;
 
 	return 0;
 }
-- 
2.24.1

_______________________________________________
linux-arm-kernel mailing list
[email-masked]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel