Subject: [PATCH 7/8] arm64: dts: zynqmp-zcu100-revC: Correct interrupt flags in examples

From: Krzysztof Kozlowski <[email-masked]>
Date: Tue, 8 Sep 2020 17:02:40 +0200

GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
These are simple defines so they could be used in DTS but they will not
have the same meaning:
1. GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE
2. GPIO_ACTIVE_LOW  = 1 = IRQ_TYPE_EDGE_RISING

Correct the interrupt flags, assuming the author of the code wanted some
logical behavior behind the name "ACTIVE_xxx", this is:
  ACTIVE_LOW => IRQ_TYPE_LEVEL_LOW

Signed-off-by: Krzysztof Kozlowski <[email-masked]>

---

Not tested on HW.
---
 arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
index d60110ad8367..c9460693f4e9 100644
--- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
+++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
@@ -186,7 +186,7 @@
 				compatible = "ti,tps65086";
 				reg = <0x5e>;
 				interrupt-parent = <&gpio>;
-				interrupts = <77 GPIO_ACTIVE_LOW>;
+				interrupts = <77 IRQ_TYPE_LEVEL_LOW>;
 				#gpio-cells = <2>;
 				gpio-controller;
 			};
-- 
2.17.1

_______________________________________________
linux-arm-kernel mailing list
[email-masked]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel