Subject: Re: [PATCH v7 7/7] arm64: dts: add dts nodes for MT6779

From: Matthias Brugger <[email-masked]>
Date: Fri, 10 Jul 2020 15:47:28 +0200

On 02/07/2020 14:57, Hanks Chen wrote:
> this adds initial MT6779 dts settings for board support,
> including cpu, gic, timer, ccf, pinctrl, uart, sysirq...etc.
> 
> Signed-off-by: Hanks Chen <[email-masked]>
> ---
>   arch/arm64/boot/dts/mediatek/Makefile       |    1 +
>   arch/arm64/boot/dts/mediatek/mt6779-evb.dts |   31 +++
>   arch/arm64/boot/dts/mediatek/mt6779.dtsi    |  271 +++++++++++++++++++++++++++
>   3 files changed, 303 insertions(+)
>   create mode 100644 arch/arm64/boot/dts/mediatek/mt6779-evb.dts
>   create mode 100644 arch/arm64/boot/dts/mediatek/mt6779.dtsi
> 
[...]
> +
> +		uart2: serial@11004000 {
> +			compatible = "mediatek,mt6779-uart",
> +				     "mediatek,mt6577-uart";
> +			reg = <0 0x11004000 0 0x400>;
> +			interrupts = <GIC_SPI 117 IRQ_TYPE_LEVEL_LOW>;
> +			clocks = <&clk26m>, <&infracfg_ao CLK_INFRA_UART1>;

I suppose that should be:

clocks = <&clk26m>, <&infracfg_ao CLK_INFRA_UART2>;

Regards,
Matthias

> +			clock-names = "baud", "bus";
> +			status = "disabled";
> +		};
> +
> +		audio: clock-controller@11210000 {
> +			compatible = "mediatek,mt6779-audio", "syscon";
> +			reg = <0 0x11210000 0 0x1000>;
> +			#clock-cells = <1>;
> +		};
> +
> +		mfgcfg: clock-controller@13fbf000 {
> +			compatible = "mediatek,mt6779-mfgcfg", "syscon";
> +			reg = <0 0x13fbf000 0 0x1000>;
> +			#clock-cells = <1>;
> +		};
> +
> +		mmsys: syscon@14000000 {
> +			compatible = "mediatek,mt6779-mmsys", "syscon";
> +			reg = <0 0x14000000 0 0x1000>;
> +			#clock-cells = <1>;
> +		};
> +
> +		imgsys: clock-controller@15020000 {
> +			compatible = "mediatek,mt6779-imgsys", "syscon";
> +			reg = <0 0x15020000 0 0x1000>;
> +			#clock-cells = <1>;
> +		};
> +
> +		vdecsys: clock-controller@16000000 {
> +			compatible = "mediatek,mt6779-vdecsys", "syscon";
> +			reg = <0 0x16000000 0 0x1000>;
> +			#clock-cells = <1>;
> +		};
> +
> +		vencsys: clock-controller@17000000 {
> +			compatible = "mediatek,mt6779-vencsys", "syscon";
> +			reg = <0 0x17000000 0 0x1000>;
> +			#clock-cells = <1>;
> +		};
> +
> +		camsys: clock-controller@1a000000 {
> +			compatible = "mediatek,mt6779-camsys", "syscon";
> +			reg = <0 0x1a000000 0 0x10000>;
> +			#clock-cells = <1>;
> +		};
> +
> +		ipesys: clock-controller@1b000000 {
> +			compatible = "mediatek,mt6779-ipesys", "syscon";
> +			reg = <0 0x1b000000 0 0x1000>;
> +			#clock-cells = <1>;
> +		};
> +
> +	};
> +};
> 

_______________________________________________
linux-arm-kernel mailing list
[email-masked]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel