Subject: [PATCH v5 10/14] ARM: OMAP2+: gpmc: waitpin helper

From: [email-masked] (Jon Hunter)
Date: Mon, 11 Jun 2012 17:59:09 -0500

On 06/11/2012 09:27 AM, Afzal Mohammed wrote:
> Helper for configuring waitpin. There are two parts to it;
> configuring at CS level and the other at device level.
> A device embedding multiple CS has been provided the
> capability to use same waitpin (different waitpins has not
> been supported as presently there are no GPMC peripherals
> doing so)
> 
> Signed-off-by: Afzal Mohammed <[email-masked]>
> ---
>  arch/arm/mach-omap2/gpmc.c             |  122 ++++++++++++++++++++++++++++++++
>  arch/arm/plat-omap/include/plat/gpmc.h |    9 +++
>  2 files changed, 131 insertions(+)
> 
> diff --git a/arch/arm/mach-omap2/gpmc.c b/arch/arm/mach-omap2/gpmc.c
> index 5a6f708..9073a8a 100644
> --- a/arch/arm/mach-omap2/gpmc.c
> +++ b/arch/arm/mach-omap2/gpmc.c
> @@ -75,6 +75,8 @@
>  #define	GPMC_CONFIG6_CYCLE2CYCLEDIFFCSEN	BIT(6)
>  #define	GPMC_CONFIG6_CYCLE2CYCLESAMECSEN	BIT(7)
>  
> +#define	GPMC_CONFIG_WAITPIN_POLARITY_SHIFT	0x8
> +
>  #define GPMC_CS0_OFFSET		0x60
>  #define GPMC_CS_SIZE		0x30
>  
> @@ -93,6 +95,19 @@
>   */
>  #define	GPMC_NR_IRQ		2
>  
> +enum {
> +	GPMC_WAITPIN_IDX0,
> +	GPMC_WAITPIN_IDX1,
> +	GPMC_WAITPIN_IDX2,
> +	GPMC_WAITPIN_IDX3,
> +	GPMC_NR_WAITPIN
> +};

Max number of wait pins is 3 for omap4/5. I know that we discussed this
in the past, but are you not supporting these devices are the moment? I
know that you have not done the hwmod for these, but still I was hoping
that you would take these into account.

> +
> +enum {
> +	LOW,
> +	HIGH
> +};

To be honest, I don't see the point in either of the above enums when
you have the definitions at the bottom. Seems that one set of
definitions should be enough.

>  struct gpmc_client_irq	{
>  	unsigned		irq;
>  	u32			bitmask;
> @@ -140,6 +155,8 @@ struct gpmc_peripheral {
>  	struct platform_device	*pdev;
>  };
>  
> +static unsigned gpmc_waitpin_map;
> +
>  static struct gpmc_client_irq gpmc_client_irq[GPMC_NR_IRQ];
>  static struct irq_chip gpmc_irq_chip;
>  static unsigned gpmc_irq_start;
> @@ -1162,6 +1179,62 @@ static void gpmc_print_cs_timings(int cs)
>  			gpmc_get_one_timing(cs, GPMC_CS_CONFIG6, 7, 7));
>  }
>  
> +static int gpmc_setup_cs_waitpin(struct gpmc_peripheral *g_per, unsigned cs,
> +							unsigned conf)
> +{
> +	unsigned idx;
> +	bool polarity = 0;
> +	u32 l = gpmc_cs_read_reg(cs, GPMC_CS_CONFIG1);
> +
> +	switch (conf & GPMC_WAITPIN_MASK) {
> +	case GPMC_WAITPIN_0:
> +		idx =  GPMC_WAITPIN_IDX0;

For example, here you could have ...

		idx = GPMC_WAITPIN_0 - 1;
> +		break;
> +	case GPMC_WAITPIN_1:
> +		idx =  GPMC_WAITPIN_IDX1;
> +		break;
> +	case GPMC_WAITPIN_2:
> +		idx =  GPMC_WAITPIN_IDX2;
> +		break;
> +	case GPMC_WAITPIN_3:
> +		idx =  GPMC_WAITPIN_IDX3;
> +		break;
> +	/* no waitpin */
> +	case 0:
> +		return 0;
> +		break;
> +	default:
> +		dev_err(gpmc_dev, "multiple waitpins selected on CS:%u\n", cs);
> +		return -EINVAL;
> +		break;
> +	}
> +
> +	polarity = !!(conf & GPMC_WAITPIN_ACTIVE_HIGH);
> +
> +	if (g_per->have_waitpin) {
> +		if (g_per->waitpin != idx ||
> +				g_per->waitpin_polarity != polarity) {
> +			dev_err(gpmc_dev, "error: conflict: waitpin %u with polarity %d on device %s.%d\n",
> +				g_per->waitpin, g_per->waitpin_polarity,
> +				g_per->name, g_per->id);
> +			return -EBUSY;
> +		}
> +	} else {
> +		g_per->have_waitpin = true;
> +		g_per->waitpin = idx;
> +		g_per->waitpin_polarity = polarity;
> +	}
> +
> +	l |= conf & GPMC_CONFIG1_WAIT_WRITE_MON;
> +	l |= conf & GPMC_CONFIG1_WAIT_READ_MON;
> +	l &= ~GPMC_CONFIG1_WAIT_PIN_SEL_MASK;
> +	l |= GPMC_CONFIG1_WAIT_PIN_SEL(idx);
> +
> +	gpmc_cs_write_reg(cs, GPMC_CS_CONFIG1, l);
> +
> +	return 0;
> +}
> +
>  static inline unsigned gpmc_bit_to_irq(unsigned bitmask)
>  {
>  	return bitmask;
> @@ -1185,6 +1258,55 @@ static __devinit int gpmc_setup_cs_irq(struct gpmc_cs_data *cs,
>  	return n;
>  }
>  
> +static inline int gpmc_waitpin_is_reserved(unsigned waitpin)
> +{
> +	return gpmc_waitpin_map & (0x1 << waitpin);
> +}
> +
> +static inline void gpmc_reserve_waitpin(unsigned waitpin)
> +{
> +	gpmc_waitpin_map &= ~(0x1 << waitpin);
> +	gpmc_waitpin_map |= (0x1 << waitpin);
> +}
> +
> +static int gpmc_waitpin_request(unsigned waitpin)
> +{
> +	if (!(waitpin < GPMC_NR_WAITPIN))
> +		return -ENODEV;
> +
> +	if (gpmc_waitpin_is_reserved(waitpin))
> +		return -EBUSY;
> +	else
> +		gpmc_reserve_waitpin(waitpin);
> +
> +	return 0;
> +}
> +
> +static int gpmc_setup_waitpin(struct gpmc_peripheral *g_per)
> +{
> +	int ret;
> +	u32 l, shift;
> +
> +	if (!g_per->have_waitpin)
> +		return 0;
> +
> +	ret = gpmc_waitpin_request(g_per->waitpin);
> +	if (IS_ERR_VALUE(ret)) {
> +		dev_err(gpmc_dev, "waitpin %u reserved\n", g_per->waitpin);
> +		return ret;
> +	}
> +
> +	l = gpmc_read_reg(GPMC_CONFIG);
> +	shift = g_per->waitpin + GPMC_CONFIG_WAITPIN_POLARITY_SHIFT;
> +	if (g_per->waitpin_polarity == HIGH)
> +		l |= 1 << shift;
> +	else
> +		l &= ~(1 << shift);
> +	gpmc_write_reg(GPMC_CONFIG, l);

Looks like another good place for a _gpmc_cs_set_bit() function.

Jon

> +
> +	return 0;
> +}
> +
>  static __devinit int gpmc_probe(struct platform_device *pdev)
>  {
>  	u32 l;
> diff --git a/arch/arm/plat-omap/include/plat/gpmc.h b/arch/arm/plat-omap/include/plat/gpmc.h
> index ff3f32c..e1b130c 100644
> --- a/arch/arm/plat-omap/include/plat/gpmc.h
> +++ b/arch/arm/plat-omap/include/plat/gpmc.h
> @@ -64,6 +64,7 @@
>  #define GPMC_CONFIG1_WAIT_WRITE_MON     (1 << 21)
>  #define GPMC_CONFIG1_WAIT_MON_IIME(val) ((val & 3) << 18)
>  #define GPMC_CONFIG1_WAIT_PIN_SEL(val)  ((val & 3) << 16)
> +#define	GPMC_CONFIG1_WAIT_PIN_SEL_MASK	GPMC_CONFIG1_WAIT_PIN_SEL(3)
>  #define GPMC_CONFIG1_DEVICESIZE(val)    ((val & 3) << 12)
>  #define	GPMC_CONFIG1_DEVICESIZE_8	GPMC_CONFIG1_DEVICESIZE(0)
>  #define GPMC_CONFIG1_DEVICESIZE_16      GPMC_CONFIG1_DEVICESIZE(1)
> @@ -78,6 +79,14 @@
>  #define GPMC_CONFIG1_FCLK_DIV4          (GPMC_CONFIG1_FCLK_DIV(3))
>  #define GPMC_CONFIG7_CSVALID		(1 << 6)
>  
> +#define	GPMC_WAITPIN_ACTIVE_HIGH	(1 << 4)
> +#define	GPMC_WAITPIN_ACTIVE_LOW		(0 << 4)
> +#define	GPMC_WAITPIN_0			(1 << 0)
> +#define	GPMC_WAITPIN_1			(1 << 1)
> +#define	GPMC_WAITPIN_2			(1 << 2)
> +#define	GPMC_WAITPIN_3			(1 << 3)
> +#define	GPMC_WAITPIN_MASK		(GPMC_WAITPIN_0 | GPMC_WAITPIN_1 | \
> +					GPMC_WAITPIN_2 | GPMC_WAITPIN_3)
>  #define GPMC_DEVICETYPE_NOR		0
>  #define GPMC_DEVICETYPE_NAND		2
>  #define GPMC_CONFIG_WRITEPROTECT	0x00000010