Subject: [PATCH] ARM: dts: omap3-beagle-xm: Add USB Host support for Rev Ax/Bx

From: [email-masked] (Roger Quadros)
Date: Mon, 15 Apr 2013 15:39:15 +0300

On 04/15/2013 03:35 PM, Roger Quadros wrote:
> Provide RESET and Power regulators for the USB PHY,
> the USB Host port mode and the PHY device.
> 
> Also provide pin multiplexer information for USB host
> pins.
> 
> This will not work for Rev Cx boards because of reversed logic
> for USB_POWER_Enable.
> 
> CC: Beno?t Cousson <[email-masked]>
> Signed-off-by: Roger Quadros <[email-masked]>
> ---
>  arch/arm/boot/dts/omap3-beagle-xm.dts |   62 +++++++++++++++++++++++++++++++++
>  1 files changed, 62 insertions(+), 0 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/omap3-beagle-xm.dts b/arch/arm/boot/dts/omap3-beagle-xm.dts
> index 5a31964..d394c51 100644
> --- a/arch/arm/boot/dts/omap3-beagle-xm.dts
> +++ b/arch/arm/boot/dts/omap3-beagle-xm.dts
> @@ -57,6 +57,60 @@
>  		ti,mcbsp = <&mcbsp2>;
>  		ti,codec = <&twl_audio>;
>  	};
> +
> +	/* HS USB Port 2 RESET */
> +	hsusb2_reset: hsusb2_reset_reg {
> +		compatible = "regulator-fixed";
> +		regulator-name = "hsusb2_reset";
> +		regulator-min-microvolt = <3300000>;
> +		regulator-max-microvolt = <3300000>;
> +		gpio = <&gpio5 19 0>;	/* gpio_147 */
> +		startup-delay-us = <70000>;
> +		enable-active-high;
> +	};
> +
> +	/* HS USB Port 2 Power */
> +	hsusb2_power: hsusb2_power_reg {
> +		compatible = "regulator-fixed";
> +		regulator-name = "hsusb2_vbus";
> +		regulator-min-microvolt = <3300000>;
> +		regulator-max-microvolt = <3300000>;
> +		gpio = <&twl_gpio 18 0>;	/* GPIO LEDA */
> +		startup-delay-us = <70000>;
> +		enable-active-high;	/* FIXME: active-low for Rev. C */

Benoit & Tony,

Any ideas how to tackle the reversed logic for Rev. C boards?

> +	};
> +
> +	/* HS USB Host PHY on PORT 2 */
> +	hsusb2_phy: hsusb2_phy {
> +		compatible = "usb-nop-xceiv";
> +		reset-supply = <&hsusb2_reset>;
> +		vcc-supply = <&hsusb2_power>;
> +	};
> +
> +};

cheers,
-roger