Subject: [PATCH 2/2] memory: ti-aemif: add bindings for AEMIF driver

From: [email-masked] (ivan.khoronzhuk)
Date: Wed, 20 Nov 2013 21:03:06 +0200

On 11/20/2013 08:21 PM, Jean-Christophe PLAGNIOL-VILLARD wrote:
>> +				the chip select signal.
>> +				Minimum value is 1 (0 treated as 1).
>> +
>> +- ti,cs-wsetup:		write setup width, ns
>> +				Time between the beginning of a memory cycle
>> +				and the activation of write strobe.
>> +				Minimum value is 1 (0 treated as 1).
>> +
>> +- ti,cs-wstrobe:	write strobe width, ns
>> +				Time between the activation and deactivation of
>> +				the write strobe.
>> +				Minimum value is 1 (0 treated as 1).
>> +
>> +- ti,cs-whold:		write hold width, ns
>> +				Time between the deactivation of the write
>> +				strobe and the end of the cycle (which may be
>> +				either an address change or the deactivation of
>> +				the chip select signal.
>> +				Minimum value is 1 (0 treated as 1).
>> +
>> +If any of the above parameters are absent, current parameter value will be taken
>> +from the corresponding HW reg.
>> +
>> +The name for cs node must be in format csN, where N is the cs number.
> 
> this is wired we should use reg instead to represent the cs as done for SPI
> or a an other property
> 
> Best Regards,
> J.
> 

Ok, I will add new property cs-chipselect like following :

ti,cs-chipselect:	number of chipselect. Indicates on the
			aemif driver which chipselect is used
			for accessing the memory.
			For compatibles "ti,davinci-aemif" and 
			"ti,keystone-aemif" it can be in range [0-3].
			For compatible "ti,omap-L138-aemif" range is [2-5].

Is it OK?

-- 
Regards,
Ivan Khoronzhuk