Subject: [PATCH v2 2/2] ARM: dts: am33xx: Move wkup_m3 node to soc node and add ranges

From: [email-masked] (Suman Anna)
Date: Thu, 5 Mar 2015 10:46:01 -0600

On 03/05/2015 09:40 AM, Tony Lindgren wrote:
> * Dave Gerlach <[email-masked]> [150304 20:14]:
Dave,

Looks like the commit message disappeared during your patch preparation.

>> Signed-off-by: Suman Anna <[email-masked]>
>> Signed-off-by: Dave Gerlach <[email-masked]>
>> ---
>>  arch/arm/boot/dts/am33xx.dtsi | 21 +++++++++++++--------
>>  1 file changed, 13 insertions(+), 8 deletions(-)
>>
>> diff --git a/arch/arm/boot/dts/am33xx.dtsi b/arch/arm/boot/dts/am33xx.dtsi
>> index acd3705..086415c 100644
>> --- a/arch/arm/boot/dts/am33xx.dtsi
>> +++ b/arch/arm/boot/dts/am33xx.dtsi
>> @@ -77,10 +77,23 @@
>>  	 */
>>  	soc {
>>  		compatible = "ti,omap-infra";
>> +		#address-cells = <1>;
>> +		#size-cells = <1>;
>> +		ranges = <0x0     0x44d00000 0x4000>,
>> +			 <0x80000 0x44d80000 0x2000>;
>> +
> 
> I think putting the ranges here will cause issues for adding
> ranges for anything else.
> 
> How about do something like this instead (untested):
> 
> ocp {
> 	l4_wkup: l4_wkup at 44c00000 {
> 		compatible = "am335-l4-wkup", "simple-bus";
> 		ranges = <0 0x44c00000 0x3fffff>;
> 
> 		wkup_m3: wkup_m3 at 44d00000 {
> 			compatible = "ti,am3353-wkup-m3";
> 			reg = <0x1000000     0x4000>,	/* M3 UMEM */
> 			      <0x180000	     0x2000>;	/* M3 DMEM */
> 			ti,hwmods = "wkup_m3";
> 			ti,pm-firmware = "am335x-pm-firmware.elf";
> 		};
> 
> 		...
> 	};
> };
> 
> That way we can start moving also the other l4_wkup components there
> eventuallly without having to redo the ranges again for wkup_m3.
> 
> You can also look at how the scm_conf was done for dm816x.dtsi for an
> example, and the recent large set of patches posted by Tero.
> 
Tony,

Thanks, I will take a look at this. I initially tried adding to ocp node
directly, but obviously it had issues.

But in general, you are ok with the ranges approach right, rather than
having to define another property with virtual addresses. These devices
are not on a separate bus like PCI, so I placed them in the soc node,
and expect only special devices like processors to kinda go under that node.

regards
Suman