Subject: [PATCH 11/11] dt: Exynos: add Snow SPI NOR node.

From: [email-masked] (Krzysztof Kozlowski)
Date: Thu, 04 Jun 2015 11:04:18 +0900

On 04.06.2015 06:26, Michal Suchanek wrote:
> The Snow has onboard SPI NOR flash which contains the bootloader.
> 
> Add DT node for this flash chip. The flash is rated 133MHz but the pl330
> controller can transfer only up to 128 bytes at this speed so use more
> conservative settings. Even at 40MHz pl330 can transfer at most 64k with
> the current driver.
> 
> Signed-off-by: Michal Suchanek <[email-masked]>
> ---
>  arch/arm/boot/dts/exynos5250-snow.dts | 12 ++++++++++++
>  1 file changed, 12 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/exynos5250-snow.dts b/arch/arm/boot/dts/exynos5250-snow.dts
> index 1fa72cf..38e4cda 100644
> --- a/arch/arm/boot/dts/exynos5250-snow.dts
> +++ b/arch/arm/boot/dts/exynos5250-snow.dts
> @@ -691,6 +691,18 @@
>  	num-cs = <1>;
>  	cs-gpios = <&gpa2 5 0>;
>  	status = "okay";
> +		flash: m25p80 at 0 {

The indentation looks odd. This should be at the same level as "status".

> +			#address-cells = <1>;
> +			#size-cells = <1>;
> +			compatible = "jedec,spi-nor";
> +			reg = <0>;
> +			spi-max-frequency = <40000000>;

So actually you wanted 133 MHz but as a workaround for DMA issue you use
40 MHz, right? Could you add here a small TODO note in comment about it?

Best regards,
Krzysztof