Subject: [PATCH] soc: mediatek: PMIC wrap: clear the STAUPD_TRIG bit of WDT_SRC_EN

From: [email-masked] (Matthias Brugger)
Date: Thu, 21 Jan 2016 10:18:01 +0100

On 20/01/16 12:11, Henry Chen wrote:
> On Wed, 2016-01-20 at 02:32 -0800, Daniel Kurtz wrote:
>> On Tue, Jan 19, 2016 at 8:52 PM, Henry Chen <[email-masked]> wrote:
>>> Since STAUPD interrupts aren't handled on mt8173, disable watchdog timeout
>>> monitor of STAUPD to avoid WDT_INT triggered by STAUPD.
>>>
>>> Signed-off-by: Henry Chen <[email-masked]>
>>
>>> ---
>>>   drivers/soc/mediatek/mtk-pmic-wrap.c | 19 +++++++++++++++++--
>>>   1 file changed, 17 insertions(+), 2 deletions(-)
>>>
>>> diff --git a/drivers/soc/mediatek/mtk-pmic-wrap.c b/drivers/soc/mediatek/mtk-pmic-wrap.c
>>> index af919b1..998f561 100644
>>> --- a/drivers/soc/mediatek/mtk-pmic-wrap.c
>>> +++ b/drivers/soc/mediatek/mtk-pmic-wrap.c
>>> @@ -60,6 +60,15 @@
>>>   #define PWRAP_MAN_CMD_OP_OUTD          (0x9 << 8)
>>>   #define PWRAP_MAN_CMD_OP_OUTQ          (0xa << 8)
>>>
>>> +/* macro for Watch Dog Timer Source */
>>> +#define PWRAP_WDT_SRC_EN_STAUPD_TRIG           (1 << 25)
>>> +#define PWRAP_WDT_SRC_EN_HARB_STAUPD_DLE       (1 << 20)
>>> +#define PWRAP_WDT_SRC_EN_HARB_STAUPD_ALE       (1 << 6)
>>> +#define PWRAP_WDT_SRC_MASK_ALL                 0xffffffff
>>> +#define PWRAP_WDT_SRC_MASK_NO_STAUPD   ~(PWRAP_WDT_SRC_EN_STAUPD_TRIG | \
>>> +                                         PWRAP_WDT_SRC_EN_HARB_STAUPD_DLE | \
>>> +                                         PWRAP_WDT_SRC_EN_HARB_STAUPD_ALE)
>>> +
>>>   /* macro for slave device wrapper registers */
>>>   #define PWRAP_DEW_BASE                 0xbc00
>>>   #define PWRAP_DEW_EVENT_OUT_EN         (PWRAP_DEW_BASE + 0x0)
>>> @@ -830,7 +839,7 @@ MODULE_DEVICE_TABLE(of, of_pwrap_match_tbl);
>>>
>>>   static int pwrap_probe(struct platform_device *pdev)
>>>   {
>>> -       int ret, irq;
>>> +       int ret, irq, wdt_src;
>>>          struct pmic_wrapper *wrp;
>>>          struct device_node *np = pdev->dev.of_node;
>>>          const struct of_device_id *of_id =
>>> @@ -920,7 +929,13 @@ static int pwrap_probe(struct platform_device *pdev)
>>>
>>>          /* Initialize watchdog, may not be done by the bootloader */
>>>          pwrap_writel(wrp, 0xf, PWRAP_WDT_UNIT);
>>> -       pwrap_writel(wrp, 0xffffffff, PWRAP_WDT_SRC_EN);
>>> +       /*
>>> +        * Since STAUPD was not used on mt8173 platform,
>>> +        * so STAUPD of WDT_SRC which should be turned off
>>> +        */
>>
>> It is a little awkward that "!pwrap_is_mt8135(wrp)" means mt8173.  Is
>> this always true?
>> Why aren't we clearing STAUPD for mt8135 too?
>> I assume it is because mt8135 does not define this bit?
>> What about other devices that are not mt8135 or mt8173?
>
> MT8135 used STAUPD because it have pwrap event pin and it was different
> with mt8173. pwrap event have been removed on mt8173, so it no need to
> set STAUPD.
>

I think we already had this discussion once. It seems as if there are 
different versions of pmic-wrapper. An older version used by mt8135 and 
e.g. mt6589 and a newer one used by mt8173.

So I agree with Daniel that we should check pwrap_is_mt8173 instead.

Apart from that the patch looks good.

Regards,
Matthias

> Henry
>
>> Perhaps change the comment to:
>> "This driver does not use STAUPD, so clear this WDT SRC for all
>> devices for which it exists to avoid unhandled interrupts"
>>
>
>> Other than that, this patch is:
>> Reviewed-by: Daniel Kurtz <[email-masked]>
>>
>>> +       wdt_src = pwrap_is_mt8135(wrp) ?
>>> +                       PWRAP_WDT_SRC_MASK_ALL : PWRAP_WDT_SRC_MASK_NO_STAUPD;
>>> +       pwrap_writel(wrp, wdt_src, PWRAP_WDT_SRC_EN);
>>>          pwrap_writel(wrp, 0x1, PWRAP_TIMER_EN);
>>>          pwrap_writel(wrp, ~((1 << 31) | (1 << 1)), PWRAP_INT_EN);
>>>
>>> --
>>> 1.8.1.1.dirty
>>>
>
>