From: vz@mleia•com (Vladimir Zapolskiy)
To: linux-arm-kernel@lists•infradead.org
Subject: [PATCH 00/11] clk: lpc32xx: add clock support for NXP LPC32xx
Date: Wed, 10 Feb 2016 02:19:03 +0200 [thread overview]
Message-ID: <56BA81F7.4080006@mleia.com> (raw)
In-Reply-To: <loom.20160209T215103-78@post.gmane.org>
Hi Sylvain,
On 09.02.2016 23:01, Sylvain Lemieux wrote:
> Vladimir Zapolskiy <vz@...> writes:
>>
>> This changeset adds common clock framework driver for NXP LPC32xx
>> boards.
>
> Hi Vladimir,
>
> Just to let you know that we did some testing using this changeset;
> I installed patches 4 to 7, 10 & 11 on top of 4.5-rc1.
>
> I was able to run our software (SIC1 interrupt sources disable)
> without any problem a custom LPC32xx board.
this is a known issue, and I hope it will be fixed in upstream in v4.6,
the required changes in irqchip and gpiochip drivers were sent for
review some time ago, a bit more work is needed to
Also 2-3 more clean-up changes in USB host and gadget drivers are done
locally (no more need to configure clocks out of the common clock
framework), but not yet submitted, will do it tomorrow.
> We did not get any problem with the clock signals we are using.
>
Thank you for testing, I'm going to add your Tested-by tag (if you
don't mind) and submit a PR to ARM maintainers shortly.
>> Vladimir Zapolskiy (11):
>> dt-bindings: clock: add description of LPC32xx clock controller
>> dt-bindings: clock: add description of LPC32xx USB clock controller
>> dt-bindings: clock: add NXP LPC32xx clock list for consumers
>> arm: dts: lpc32xx: add device nodes for external oscillators
>> arm: dts: lpc32xx: add clock controller device node
>> arm: dts: lpc32xx: add clock properties to device nodes
>> arm: dts: lpc32xx: add USB clock controller
>> clk: lpc18xx: add NXP specific common clock framework selection
>> clk: lpc32xx: add common clock framework driver
>> arm: lpc32xx: switch to common clock framework
>> arm: dts: lpc32xx: remove clock frequency property from UART device
>> nodes
>
>
With best wishes,
Vladimir
next prev parent reply other threads:[~2016-02-10 0:19 UTC|newest]
Thread overview: 28+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-11-20 1:05 [PATCH 00/11] clk: lpc32xx: add clock support for NXP LPC32xx Vladimir Zapolskiy
2015-11-20 1:05 ` [PATCH 01/11] dt-bindings: clock: add description of LPC32xx clock controller Vladimir Zapolskiy
2015-11-20 13:58 ` Arnd Bergmann
2015-11-20 18:01 ` Vladimir Zapolskiy
2015-11-20 20:03 ` Arnd Bergmann
2015-11-20 1:05 ` [PATCH 02/11] dt-bindings: clock: add description of LPC32xx USB " Vladimir Zapolskiy
2015-11-20 16:41 ` Rob Herring
2015-11-20 18:14 ` Vladimir Zapolskiy
2015-11-20 1:05 ` [PATCH 03/11] dt-bindings: clock: add NXP LPC32xx clock list for consumers Vladimir Zapolskiy
2015-11-20 13:56 ` Arnd Bergmann
2015-11-20 17:58 ` Vladimir Zapolskiy
2015-11-20 21:07 ` Arnd Bergmann
2015-11-21 18:53 ` Vladimir Zapolskiy
2015-11-20 1:05 ` [PATCH 04/11] arm: dts: lpc32xx: add device nodes for external oscillators Vladimir Zapolskiy
2015-11-20 1:05 ` [PATCH 05/11] arm: dts: lpc32xx: add clock controller device node Vladimir Zapolskiy
2015-11-20 1:05 ` [PATCH 06/11] arm: dts: lpc32xx: add clock properties to device nodes Vladimir Zapolskiy
2015-11-20 1:05 ` [PATCH 07/11] arm: dts: lpc32xx: add USB clock controller Vladimir Zapolskiy
2015-11-20 1:05 ` [PATCH 08/11] clk: lpc18xx: add NXP specific common clock framework selection Vladimir Zapolskiy
2015-11-22 20:38 ` Joachim Eastwood
2015-11-20 1:05 ` [PATCH 09/11] clk: lpc32xx: add common clock framework driver Vladimir Zapolskiy
2015-11-20 14:04 ` Arnd Bergmann
2015-11-20 18:07 ` Vladimir Zapolskiy
2015-11-20 20:20 ` Arnd Bergmann
2015-11-29 13:00 ` Vladimir Zapolskiy
2015-11-20 1:05 ` [PATCH 10/11] arm: lpc32xx: switch to common clock framework Vladimir Zapolskiy
2015-11-20 1:05 ` [PATCH 11/11] arm: dts: lpc32xx: remove clock frequency property from UART device nodes Vladimir Zapolskiy
[not found] ` <loom.20160209T215103-78@post.gmane.org>
2016-02-10 0:19 ` Vladimir Zapolskiy [this message]
2016-02-10 14:25 ` [PATCH 00/11] clk: lpc32xx: add clock support for NXP LPC32xx Sylvain Lemieux
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=56BA81F7.4080006@mleia.com \
--to=vz@mleia$(echo .)com \
--cc=linux-arm-kernel@lists$(echo .)infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox