Subject: [PATCH v3 0/5] ACPI: parse the SPCR table

From: [email-masked] (Jeremy Linton)
Date: Thu, 18 Feb 2016 15:15:44 -0600

On 02/15/2016 12:05 PM, Aleksey Makarov wrote:
> This patchset is based on the patchset by Leif Lindholm [1]
>
> 'ARM Server Base Boot Requirements' [2] mentions SPCR (Serial Port
> Console Redirection Table) [3] as a mandatory ACPI table that
> specifies the configuration of serial console.
>
> SPCR support is included in QEMU's ARM mach-virt since 2.4 release.
>
> Introduce a new function acpi_console_check().  At the uart port
> registration, this function checks if the ACPI SPCR table specifies
> its argument of type struct uart_port to be a console
> and if so calls add_preferred_console().
>
> Use SPCR to tell if SBSA serial driver should use 32-bit access to registers.
>
> To be able to access SPCR table each time any console is registered
> change __init to __ref for early_acpi_os_unmap_memory().
>
> The patchset should be applied to tty-next.
(trimming)

This works on the JunoR2 with a new enough firmware to have the SPCR table.

Tested-by: Jeremy Linton <[email-masked]>