Subject: [PATCH v3 1/5] arm64: Broadcom Vulcan support

From: [email-masked] (Florian Fainelli)
Date: Sat, 27 Feb 2016 12:03:01 -0800

On 26/02/16 22:52, Jayachandran C wrote:
> From: Zi Shen Lim <[email-masked]>
> 
> Add a configuration option and a device tree for Broadcom's Vulcan
> ARM64 processor. vulcan.dtsi has the on-chip blocks like the PCIe
> controller, GICv3 with ITS, PMU, system timer and the pl011 UART.
> vulcan-eval.dts has definitions for a basic evaluation board.
> 
> Vulcan's processor cores support the ARMv8.1 instruction set and
> will use "brcm,vulcan" as the compatible property. The firmware
> has PSCI 0.2 support for cpu wakeup.
> 
> Signed-off-by: Zi Shen Lim <[email-masked]>
> [ updated and split dts - jchandra at broadcom.com ]
> Signed-off-by: Jayachandran C <[email-masked]>
> ---
> 
> There is a minor update to this patch.
> 
> After some discussions here, it looks like it is necessary to increase the
> PCI mem and mem64 ranges to support all the use cases. We are updating the
> firmware to use these ranges as well.
> 
> Hope it is not too late to fix this, sorry for the late churn.

V2 got merged already into next/dt64 by the arm-soc maintainers, could
you provide an incremental patch to your v2? Thanks!
--
Florian