Subject: [PATCH 2/4] ARM: dts: da850: Add an aemif node

From: [email-masked] (Sekhar Nori)
Date: Wed, 10 Aug 2016 13:18:51 +0530

On Tuesday 09 August 2016 10:45 PM, Karl Beldan wrote:
> Currently the davinci da8xx boards use the mach-davinci aemif code.
> Instantiating an aemif node into the DT allows to use the ti-aemif
> memory driver and is another step to better DT support.
> Also it will allow to properly pass the emif timings via DT.
> 
> Signed-off-by: Karl Beldan <[email-masked]>
> ---
>  arch/arm/boot/dts/da850.dtsi | 10 ++++++++++
>  1 file changed, 10 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/da850.dtsi b/arch/arm/boot/dts/da850.dtsi
> index bc10e7e..f62928c 100644
> --- a/arch/arm/boot/dts/da850.dtsi
> +++ b/arch/arm/boot/dts/da850.dtsi
> @@ -411,6 +411,16 @@
>  			dma-names = "tx", "rx";
>  		};
>  	};
> +	aemif: aemif at 68000000 {
> +		compatible = "ti,da850-aemif";
> +		#address-cells = <2>;
> +		#size-cells = <1>;
> +
> +		reg = <0x68000000 0x00008000>;
> +		ranges = <0 0 0x60000000 0x08000000
> +			  1 0 0x68000000 0x00008000>;
> +		status = "disabled";
> +	};
>  	nand_cs3 at 62000000 {
>  		compatible = "ti,davinci-nand";
>  		reg = <0x62000000 0x807ff

The nand node should be part of aemif node like it is done for keystone
boards.

Regards,
Sekhar