From: Nico -telmich- Schottelius <nico-linux-next@schottelius•org>
To: Stephen Rothwell <sfr@canb•auug.org.au>,
linux-next@vger•kernel.org, LKML <linux-kernel@vger•kernel.org>
Subject: iwlwifi-BUGs: linux-next: Tree for May 27
Date: Wed, 27 May 2009 13:59:34 +0200 [thread overview]
Message-ID: <20090527115934.GB6790@ikn.schottelius.org> (raw)
In-Reply-To: <20090527115325.GA6790@ikn.schottelius.org>
[-- Attachment #1: Type: text/plain, Size: 5124 bytes --]
Nico -telmich- Schottelius [Wed, May 27, 2009 at 01:53:25PM +0200]:
> Stephen Rothwell [Wed, May 27, 2009 at 06:15:36PM +1000]:
> > Changes since 20090526:
>
> Works on amd64 (x200), but reports some bugs.
And is still not able to connect to any ap:
[ 2939.433303] iwlagn 0000:03:00.0: PCI INT A disabled
[ 2939.476629] iwlagn: Intel(R) Wireless WiFi Link AGN driver for Linux, 1.3.27k
[ 2939.476633] iwlagn: Copyright(c) 2003-2009 Intel Corporation
[ 2939.476802] iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 2939.476835] iwlagn 0000:03:00.0: setting latency timer to 64
[ 2939.476906] iwlagn 0000:03:00.0: Detected Intel Wireless WiFi Link 5300AGN REV=0x24
[ 2939.512432] iwlagn 0000:03:00.0: Tunable channels: 13 802.11bg, 24 802.11a channels
[ 2939.512512] iwlagn 0000:03:00.0: irq 29 for MSI/MSI-X
[ 2939.516822] phy1: Selected rate control algorithm 'iwl-agn-rs'
[ 2941.587468] iwlagn 0000:03:00.0: firmware: requesting iwlwifi-5000-2.ucode
[ 2941.592879] iwlagn 0000:03:00.0: loaded firmware version 8.24.2.12
[ 2941.773363] Registered led device: iwl-phy1::radio
[ 2941.773425] Registered led device: iwl-phy1::assoc
[ 2941.773477] Registered led device: iwl-phy1::RX
[ 2941.773529] Registered led device: iwl-phy1::TX
[ 2941.806055] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 2945.977060] wlan0: authenticate with AP 00:03:52:1c:18:71
[ 2945.978983] wlan0: authenticated
[ 2945.978989] wlan0: associate with AP 00:03:52:1c:18:71
[ 2945.983260] wlan0: authenticate with AP 00:03:52:4d:bd:c1
[ 2945.987126] wlan0: authenticated
[ 2945.987133] wlan0: associate with AP 00:03:52:4d:bd:c1
[ 2945.989185] wlan0: RX AssocResp from 00:03:52:4d:bd:c1 (capab=0x21 status=0 aid=5)
[ 2945.989193] wlan0: associated
[ 2945.993099] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 2945.996542] wlan0: disassociating by local choice (reason=3)
[ 2946.012100] wlan0: authenticate with AP 00:03:52:1c:18:71
[ 2946.124737] wlan0: authenticate with AP 00:03:52:4d:e8:81
[ 2946.126610] wlan0: authenticated
[ 2946.126617] wlan0: associate with AP 00:03:52:4d:e8:81
[ 2946.324069] wlan0: associate with AP 00:03:52:4d:e8:81
[ 2946.329690] wlan0: RX AssocResp from 00:03:52:4d:e8:81 (capab=0x421 status=0 aid=2)
[ 2946.329698] wlan0: associated
[ 2946.337616] wlan0: disassociating by local choice (reason=3)
[ 2946.457055] wlan0: direct probe to AP 00:03:52:29:41:12 try 1
[ 2946.656623] wlan0: direct probe to AP 00:03:52:29:41:12 try 2
[ 2946.661436] wlan0 direct probe responded
[ 2946.661444] wlan0: authenticate with AP 00:03:52:29:41:12
[ 2946.860096] wlan0: authenticate with AP 00:03:52:29:41:12
[ 2947.060102] wlan0: authenticate with AP 00:03:52:29:41:12
[ 2947.064463] wlan0: authenticated
[ 2947.064470] wlan0: associate with AP 00:03:52:29:41:12
[ 2947.082421] wlan0: RX AssocResp from 00:03:52:29:41:12 (capab=0x421 status=0 aid=2)
[ 2947.082429] wlan0: associated
[ 2947.087086] wlan0: disassociating by local choice (reason=3)
[ 2947.189435] wlan0: authenticate with AP 00:03:52:4d:e7:91
[ 2947.192363] wlan0: authenticated
[ 2947.192371] wlan0: associate with AP 00:03:52:4d:e7:91
[ 2947.197793] wlan0: RX AssocResp from 00:03:52:4d:e7:91 (capab=0x421 status=0 aid=4)
[ 2947.197800] wlan0: associated
[ 2947.206966] wlan0: disassociating by local choice (reason=3)
[ 2947.315272] wlan0: authenticate with AP 00:03:52:4e:f3:d1
[ 2947.318183] wlan0: authenticated
[ 2947.318191] wlan0: associate with AP 00:03:52:4e:f3:d1
[ 2947.320186] wlan0: RX AssocResp from 00:03:52:4e:f3:d1 (capab=0x421 status=0 aid=7)
[ 2947.320194] wlan0: associated
[ 2947.330987] wlan0: disassociating by local choice (reason=3)
[ 2947.439431] wlan0: authenticate with AP 00:03:52:4d:d3:21
[ 2947.441455] wlan0: authenticated
[ 2947.441462] wlan0: associate with AP 00:03:52:4d:d3:21
[ 2947.444340] wlan0: RX AssocResp from 00:03:52:4d:d3:21 (capab=0x421 status=0 aid=6)
[ 2947.444347] wlan0: associated
[ 2947.459246] wlan0: disassociating by local choice (reason=3)
[ 2947.563662] wlan0: authenticate with AP 00:03:52:1c:18:71
[ 2947.565537] wlan0: authenticated
[ 2947.565544] wlan0: associate with AP 00:03:52:1c:18:71
[ 2947.567530] wlan0: RX AssocResp from 00:03:52:1c:18:71 (capab=0x421 status=0 aid=3)
[ 2947.567537] wlan0: associated
[ 2947.574397] wlan0: disassociating by local choice (reason=3)
[ 2947.692460] wlan0: direct probe to AP 00:03:52:1b:f8:31 try 1
[ 2947.896072] wlan0: direct probe to AP 00:03:52:1b:f8:31 try 2
[ 2948.092096] wlan0: direct probe to AP 00:03:52:1b:f8:31 try 3
[ 2948.292031] wlan0: direct probe to AP 00:03:52:1b:f8:31 timed out
[ 2952.698119] wlan0: direct probe to AP 00:03:52:4d:de:d1 try 1
[ 2952.896098] wlan0: direct probe to AP 00:03:52:4d:de:d1 try 2
[ 2953.096065] wlan0: direct probe to AP 00:03:52:4d:de:d1 try 3
[ 2953.296105] wlan0: direct probe to AP 00:03:52:4d:de:d1 timed out
[ 2956.477031] wlan0: no IPv6 routers present
--
Currently moving *.schottelius.org to http://www.nico.schottelius.org/ ...
PGP: BFE4 C736 ABE5 406F 8F42 F7CF B8BE F92A 9885 188C
[-- Attachment #2: Digital signature --]
[-- Type: application/pgp-signature, Size: 197 bytes --]
next prev parent reply other threads:[~2009-05-27 15:41 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-05-27 8:15 linux-next: Tree for May 27 Stephen Rothwell
2009-05-27 11:53 ` BUGs: " Nico -telmich- Schottelius
2009-05-27 11:59 ` Nico -telmich- Schottelius [this message]
2009-05-27 16:32 ` iwlwifi-BUGs: " Stephen Rothwell
2009-05-28 7:49 ` Nico -telmich- Schottelius
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20090527115934.GB6790@ikn.schottelius.org \
--to=nico-linux-next@schottelius$(echo .)org \
--cc=linux-kernel@vger$(echo .)kernel.org \
--cc=linux-next@vger$(echo .)kernel.org \
--cc=sfr@canb$(echo .)auug.org.au \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox