From: Olof Johansson <olof@lixom•net>
To: linuxppc-dev@ozlabs•org
Subject: [patch 10/35] pasemi_mac: Minor performance tweaks
Date: Thu, 05 Jul 2007 12:02:43 -0500 [thread overview]
Message-ID: <20070705170236.161722000@lixom.net> (raw)
In-Reply-To: 20070705170233.258351000@lixom.net
Various minor performance tweaks, do some explicit prefetching of packet
data, etc.
Signed-off-by: Olof Johansson <olof@lixom•net>
Index: netdev-2.6/drivers/net/pasemi_mac.c
===================================================================
--- netdev-2.6.orig/drivers/net/pasemi_mac.c
+++ netdev-2.6/drivers/net/pasemi_mac.c
@@ -481,6 +481,7 @@ static int pasemi_mac_clean_rx(struct pa
rmb();
dp = &RX_DESC(mac, n);
+ prefetchw(dp);
macrx = dp->macrx;
if (!(macrx & XCT_MACRX_O))
@@ -502,8 +503,10 @@ static int pasemi_mac_clean_rx(struct pa
if (info->dma == dma)
break;
}
+ prefetchw(info);
skb = info->skb;
+ prefetchw(skb);
info->dma = 0;
pci_unmap_single(mac->dma_pdev, dma, skb->len,
@@ -526,9 +529,7 @@ static int pasemi_mac_clean_rx(struct pa
skb_put(skb, len);
- skb->protocol = eth_type_trans(skb, mac->netdev);
-
- if ((macrx & XCT_MACRX_HTY_M) == XCT_MACRX_HTY_IPV4_OK) {
+ if (likely((macrx & XCT_MACRX_HTY_M) == XCT_MACRX_HTY_IPV4_OK)) {
skb->ip_summed = CHECKSUM_COMPLETE;
skb->csum = (macrx & XCT_MACRX_CSUM_M) >>
XCT_MACRX_CSUM_S;
@@ -538,6 +539,7 @@ static int pasemi_mac_clean_rx(struct pa
mac->stats.rx_bytes += len;
mac->stats.rx_packets++;
+ skb->protocol = eth_type_trans(skb, mac->netdev);
netif_receive_skb(skb);
dp->ptr = 0;
@@ -569,7 +571,7 @@ static int pasemi_mac_clean_tx(struct pa
for (i = start; i < mac->tx->next_to_use; i++) {
dp = &TX_DESC(mac, i);
- if (!dp || (dp->mactx & XCT_MACTX_O))
+ if (unlikely(dp->mactx & XCT_MACTX_O))
break;
count++;
@@ -957,7 +959,7 @@ static int pasemi_mac_start_tx(struct sk
struct pasemi_mac_txring *txring;
struct pasemi_mac_buffer *info;
struct pas_dma_xct_descr *dp;
- u64 dflags;
+ u64 dflags, mactx, ptr;
dma_addr_t map;
int flags;
@@ -985,6 +987,9 @@ static int pasemi_mac_start_tx(struct sk
if (dma_mapping_error(map))
return NETDEV_TX_BUSY;
+ mactx = dflags | XCT_MACTX_LLEN(skb->len);
+ ptr = XCT_PTR_LEN(skb->len) | XCT_PTR_ADDR(map);
+
txring = mac->tx;
spin_lock_irqsave(&txring->lock, flags);
@@ -1005,12 +1010,11 @@ static int pasemi_mac_start_tx(struct sk
}
}
-
dp = &TX_DESC(mac, txring->next_to_use);
info = &TX_DESC_INFO(mac, txring->next_to_use);
- dp->mactx = dflags | XCT_MACTX_LLEN(skb->len);
- dp->ptr = XCT_PTR_LEN(skb->len) | XCT_PTR_ADDR(map);
+ dp->mactx = mactx;
+ dp->ptr = ptr;
info->dma = map;
info->skb = skb;
--
next prev parent reply other threads:[~2007-07-05 17:03 UTC|newest]
Thread overview: 46+ messages / expand[flat|nested] mbox.gz Atom feed top
2007-07-05 17:02 [patch 00/35] PA Semi patch set Olof Johansson
2007-07-05 17:02 ` [patch 01/35] pasemi: rename platform Olof Johansson
2007-07-08 23:52 ` Stephen Rothwell
2007-07-09 0:18 ` Olof Johansson
2007-07-09 7:23 ` Stephen Rothwell
2007-07-09 17:19 ` Olof Johansson
2007-07-09 17:21 ` Olof Johansson
2007-07-05 17:02 ` [patch 02/35] PA Semi EDAC driver Olof Johansson
2007-07-05 17:02 ` [patch 03/35] Change powerpc64 ioaddr_t to u_int Olof Johansson
2007-07-05 17:02 ` [patch 04/35] pasemi_mac: Fix TX interrupt threshold Olof Johansson
2007-07-05 17:02 ` [patch 05/35] pasemi_mac: Clean TX ring in poll Olof Johansson
2007-07-05 17:02 ` [patch 06/35] pasemi_mac: Abstract out register access Olof Johansson
2007-07-05 17:02 ` [patch 07/35] pasemi_mac: stop using the pci config space accessors for register read/writes Olof Johansson
2007-07-26 21:25 ` Marian Balakowicz
2007-07-28 8:35 ` Olof Johansson
2007-08-01 9:27 ` Marian Balakowicz
2007-07-05 17:02 ` [patch 08/35] pasemi_mac: Enable L2 caching of packet headers Olof Johansson
2007-07-05 17:02 ` [patch 09/35] pasemi_mac: Simplify memcpy for short receives Olof Johansson
2007-07-05 17:02 ` Olof Johansson [this message]
2007-07-05 17:02 ` [patch 11/35] pasemi_mac: Reduce locking when cleaning TX ring Olof Johansson
2007-07-05 17:02 ` [patch 12/35] pasemi_mac: Enable LLTX Olof Johansson
2007-07-05 17:02 ` [patch 13/35] Cleanup marvell phy driver init Olof Johansson
2007-07-05 17:02 ` [patch 14/35] Add 88E1112 PHY ID to the marvell driver Olof Johansson
2007-07-05 17:02 ` [patch 15/35] Export HID registers via sysfs Olof Johansson
2007-07-05 17:02 ` [patch 16/35] Electra ide platform glue Olof Johansson
2007-07-05 17:02 ` [patch 17/35] CF driver for PA Semi Electra Olof Johansson
2007-07-05 17:02 ` [patch 18/35] Spread IRQs among cpus by default Olof Johansson
2007-07-05 17:02 ` [patch 19/35] Improve machine check output Olof Johansson
2007-07-05 17:02 ` [patch 20/35] Remove idle_spin function pointer Olof Johansson
2007-07-05 17:02 ` [patch 21/35] Use MSR_PMM to disable profiling of the idle loop Olof Johansson
2007-07-05 17:02 ` [patch 22/35] Work around errata 4111 Olof Johansson
2007-07-05 17:02 ` [patch 23/35] Work around UART erratas Olof Johansson
2007-07-05 17:02 ` [patch 24/35] Work around errata 4628 Olof Johansson
2007-07-05 17:02 ` [patch 25/35] Work around errata 4025 Olof Johansson
2007-07-05 17:02 ` [patch 26/35] Work around errata 4713 Olof Johansson
2007-07-05 17:03 ` [patch 27/35] Work around errata 4290 Olof Johansson
2007-07-05 18:50 ` Gabriel Paubert
2007-07-05 19:26 ` Olof Johansson
2007-07-05 17:03 ` [patch 28/35] Work around errata 4712 Olof Johansson
2007-07-05 17:03 ` [patch 29/35] Work around errata 4910 Olof Johansson
2007-07-05 17:03 ` [patch 30/35] Disable PURR on pa6t Olof Johansson
2007-07-05 17:03 ` [patch 31/35] Work around errata 4161 Olof Johansson
2007-07-05 17:03 ` [patch 32/35] Dont reset openpic on init Olof Johansson
2007-07-05 17:03 ` [patch 33/35] Work around errata 5667 Olof Johansson
2007-07-05 17:03 ` [patch 34/35] Work around errata 4505 Olof Johansson
2007-07-05 17:03 ` [patch 35/35] Work around errata 5652 Olof Johansson
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20070705170236.161722000@lixom.net \
--to=olof@lixom$(echo .)net \
--cc=linuxppc-dev@ozlabs$(echo .)org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox