ppcboot 0.7.1 (Jan 8 2001 - 16:20:48) Initializing... CPU: IBM PowerPC 405GP Rev. C at 198 MHz (PLB=99, OPB=49, EBC=33 MHz) PCI sync clock at 33 MHz, internal PCI arbiter enabled 16 kB I-Cache 8 kB D-Cache Board: ### No HW ID - assuming CPCI405 FPGA: cpci4052.ncd s05xlvq100 2000/11/29 14:57:32 DRAM: 16 MB FLASH: 4 MB IDE: Bus 0: OK Device 0: Model: SanDisk SDCFB-64 Serial #: 213006F040 Capacity: 61.3 MB = 0.1 GB Input: serial Output: serial Hit any key to stop autoboot: 3  2  0 => bootp ENET Speed is 10 Mbs... HALF duplex connection BOOTP broadcast 1 ARP broadcast 1 TFTP from server 10.0.5.190; our IP address is 10.0.3.176 Filename '/tftpboot/pImage'. Size is 580 kB => 91000 Bytes Load address: 0x100000 Loading: *#################################################################################################################### done => bootm ## Booting Linux kernel at 00100000 ... Image Name: Test-Image Image Type: PowerPC Linux Kernel Image (gzip compressed) Data Size: 593782 Bytes = 579 kB = 0 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK ---------- progress: 0x200 id mach(): done Linux version 2.4.2-mvista_010303 (frank@pc-linux-dev) (gcc version 2.95.2 19991030 (2.95.3 prerelease/franzo)) #7 Tue Mar 20 20:43:35 CET 2001 ---------- progress: 0x3eab setup_arch: enter ---------- progress: 0x3eab setup_arch: bootmem ---------- progress: 0x3eab arch: exit On node 0 totalpages: 4096 zone(0): 4096 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: bootargs1=root=/dev/nfs ip=10.0.3.176:10.0.5.190:10.0.0.79:255.255.0.0 nfsroot=10.0.5.190:/opt/hardhat/devkit/ppc/4xx/target Warning: real time clock seems stuck! Calibrating delay loop... 197.83 BogoMIPS Memory: 14500k available (1064k kernel code, 436k data, 64k init, 0k highmem) Dentry-cache hash table entries: 2048 (order: 2, 16384 bytes) Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes) Page-cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 1024 (order: 1, 8192 bytes) POSIX conformance testing by UNIFIX PCI: Probing PCI hardware PCI: Cannot allocate resource region 0 of device 00:00.0 PCI: Cannot allocate resource region 2 of device 00:00.0 PCI: Cannot allocate resource region 3 of device 00:00.0 PCI: Cannot allocate resource region 4 of device 00:00.0 PCI: Cannot allocate resource region 5 of device 00:00.0 ---------- progress: 0xffff Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Starting kswapd v1.8 i2c-core.o: i2c core module i2c-dev.o: i2c /dev entries driver module i2c-core.o: driver i2c-dev dummy driver registered. pty: 256 Unix98 ptys configured block: queued sectors max/low 9554kB/3184kB, 64 slots per queue RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize loop: enabling 8 loop devices Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx cpci405ide: physical address=f0100000 cpci405ide: mapped address=da000000 ide0: CPCI405 IDE interface hda: SanDisk SDCFB-64, ATA DISK drive ide0 at 0xda000000-0xda000007,0xda00000e on irq 31 hda: 125440 sectors (64 MB) w/1KiB Cache, CHS=490/8/32 Partition check: hda: hda1 phy speed read failed phy duplex read failed <5>eth0: PPC405 EMAC 10 Mbs Half duplex MAC 00:02:27:00:00:6b Serial driver version 5.02 (2000-08-09) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x0000 (irq = 0) is a 16550A ttyS01 at 0x0000 (irq = 1) is a 16550A Real Time Clock Driver v1.10d PPC 405 gpio driver version 00.08.02.d PPC 405 watchdog driver v0.3 PPP generic driver version 2.4.1 PPP Deflate Compression module registered PPC 405 iic (i2c) algorithm module 2001.03.01 iic_ppc405_init: PPC 405 iic adapter module enable_irq(2) unbalanced i2c-dev.o: Registered 'PPC405 IIC adapter' as minor 0 i2c-core.o: adapter PPC405 IIC adapter registered as adapter 0. iic_ppc405_init: found device at 0xef600500. NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 1024 bind 1024) Reset ethernet interfaces eth0: PPC405 Enet open completed NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. Looking up port of RPC 100003/2 on 10.0.5.190 Looking up port of RPC 100005/2 on 10.0.5.190 VFS: Mounted root (nfs filesystem) readonly. Freeing unused kernel memory: 64k init 4k openfirmware INIT: version 2.77 booting sh: xmalloc: cannot INIT: Entering runlevel: 3 sh: xmalloc: cannot allocate 8 bytes (0 bytes allocated) sh: xmalloc: cannot allocate 8 bytes (0 bytes allocated) sh: xmalloc: cannot allocate 8 bytes (0 bytes allocated) sh: xmalloc: cannot allocate 8 bytes (0 bytes allocated) sh: xmalloc: cannot allocate 8 bytes (0 bytes allocated) sh: xmalloc: cannot allocate 8 bytes (0 bytes allocated) sh: xmalloc: cannot allocate 8 bytes (0 bytes allocated) sh: xmalloc: cannot allocate 8 bytes (0 bytes allocated) sh: xmalloc: cannot allocate 8 bytes (0 bytes allocated) INIT: Id "sh" respawning too fast: disabled for 5 minutes INIT: no more processes left in this runlevel