Subject: Re: fs_enet on MPC885ADS

From: Vitaly Bordug <[email-masked]>
Date: Wed, 10 Aug 2005 11:25:31 +0400

Hi, Peter
Schaefer-Hutter, Peter wrote:
> Hi there,
> 
> Are there any boot options needed to enable the fs_enet driver
> on the MPC885ADS? I replaced CONFIG_DUET with CONFIG_MPC885ADS
> in drivers/net/fs_enet/mac-fec.c, but only got
> 
>   fs_enet.c:v0.1 (May 6, 2005)
>   NET: Registered protocol family 2
>   IP route cache hash table entries: 128 (order: -3, 512 bytes)
>   TCP established hash table entries: 512 (order: 0, 4096 bytes)
>   TCP bind hash table entries: 512 (order: -1, 2048 bytes)
>   TCP: Hash tables configured (established 512 bind 512)
>   TCP reno registered
>   TCP bic registered
>   NET: Registered protocol family 1
>   NET: Registered protocol family 17
>   IP-Config: Device `eth0' not found.
> 
Since this driver is platform-device based, you need to configure the PD 
structures. I'll try to submit a patch which will cover this...
> Reason i'm asking is that the current cpm_uart driver doesn't work
> with the SCC3 ethernet driver included in the MPC885 board support
> (as soon as ethernet is initialized, console output stops).
> 
This is very interesting since AFAIR SCC3 eth will not work with SMC2 on 
my board, but maybe something is changed. Anyway, oue fs_enet is pretty 
close to upstream so it would be nice if you will use (and test :)) it.
> Best regards,
> 
>  Peter
> _______________________________________________
> Linuxppc-embedded mailing list
> [email-masked]
> https://ozlabs.org/mailman/listinfo/linuxppc-embedded
> 
> 

-- 
Sincerely,
Vitaly