Subject: [PATCH 2/9] ixgbe: Fix ethtool output with advertised mode.

From: Jeff Kirsher <[email-masked]>
Date: Wed, 01 Apr 2009 00:33:02 -0700

From: Don Skidmore <[email-masked]>

Ethtool tries to get advertised speed from phy.autoneg_advertised.
However for copper media this wasn't happening until later do to
an other fix which moved mac.ops.setup_link_speed placement in
ixgbe_link_config(). This patch will display the default advertised
speeds if it can't yet get this information from phy.autoneg_advertised.

Signed-off-by: Don Skidmore <[email-masked]>
Acked-by: Mallikarjuna R Chilakala <[email-masked]>
Acked-by: Peter P Waskiewicz Jr <[email-masked]>
Signed-off-by: Jeff Kirsher <[email-masked]>
---

 drivers/net/ixgbe/ixgbe_ethtool.c |    9 +++++++++
 1 files changed, 9 insertions(+), 0 deletions(-)

diff --git a/drivers/net/ixgbe/ixgbe_ethtool.c b/drivers/net/ixgbe/ixgbe_ethtool.c
index 18ecba7..34b4a84 100644
--- a/drivers/net/ixgbe/ixgbe_ethtool.c
+++ b/drivers/net/ixgbe/ixgbe_ethtool.c
@@ -129,6 +129,15 @@ static int ixgbe_get_settings(struct net_device *netdev,
 			ecmd->advertising |= ADVERTISED_10000baseT_Full;
 		if (hw->phy.autoneg_advertised & IXGBE_LINK_SPEED_1GB_FULL)
 			ecmd->advertising |= ADVERTISED_1000baseT_Full;
+		/*
+		 * It's possible that phy.autoneg_advertised may not be
+		 * set yet.  If so display what the default would be -
+		 * both 1G and 10G supported.
+		 */
+		if (!(ecmd->advertising & (ADVERTISED_1000baseT_Full |
+					   ADVERTISED_10000baseT_Full)))
+			ecmd->advertising |= (ADVERTISED_10000baseT_Full |
+					      ADVERTISED_1000baseT_Full);
 
 		ecmd->port = PORT_TP;
 	} else if (hw->phy.media_type == ixgbe_media_type_backplane) {