Subject: Re: Regression: Wake on LAN doesn't work in sky2 with 2.6.33-rc4-git2

From: Stephen Hemminger <[email-masked]>
Date: Tue, 19 Jan 2010 10:51:05 -0800

Is this better worse or the same? It make sure that some
registers are set on resume that might matter.

--- a/drivers/net/sky2.c	2010-01-19 10:32:47.549541152 -0800
+++ b/drivers/net/sky2.c	2010-01-19 10:49:06.726853816 -0800
@@ -3002,11 +3002,17 @@ static void sky2_reset(struct sky2_hw *h
 	u32 hwe_mask = Y2_HWE_ALL_MASK;
 
 	/* disable ASF */
-	if (hw->chip_id == CHIP_ID_YUKON_EX) {
+	if (hw->chip_id == CHIP_ID_YUKON_EX ||
+	    hw->chip_id == CHIP_ID_YUKON_SUPR) {
+		/* stop the watchdog */
+		sky2_write32(hw, CPU_WDOG, 0);
+
 		status = sky2_read16(hw, HCU_CCSR);
 		status &= ~(HCU_CCSR_AHB_RST | HCU_CCSR_CPU_RST_MODE |
 			    HCU_CCSR_UC_STATE_MSK);
+		status &= ~HCU_CCSR_CPU_CLK_DIVIDE_MSK;
 		sky2_write16(hw, HCU_CCSR, status);
+		sky2_write32(hw, CPU_WDOG, 0);
 	} else
 		sky2_write8(hw, B28_Y2_ASF_STAT_CMD, Y2_ASF_RESET);
 	sky2_write16(hw, B0_CTST, Y2_ASF_DISABLE);
@@ -4807,11 +4813,12 @@ static int sky2_resume(struct pci_dev *p
 
 	pci_enable_wake(pdev, PCI_D0, 0);
 
-	/* Re-enable all clocks */
-	if (hw->chip_id == CHIP_ID_YUKON_EX ||
-	    hw->chip_id == CHIP_ID_YUKON_EC_U ||
-	    hw->chip_id == CHIP_ID_YUKON_FE_P)
-		sky2_pci_write32(hw, PCI_DEV_REG3, 0);
+	/* Enable all clocks and check for bad PCI access */
+	err = pci_write_config_dword(pdev, PCI_DEV_REG3, 0);
+	if (err)
+		goto out;
+
+	sky2_write8(hw, B0_CTST, CS_RST_CLR);
 
 	sky2_reset(hw);
 	sky2_write32(hw, B0_IMSK, Y2_IS_BASE);