Subject: Re: Figuring out how vti works

From: Steffen Klassert <[email-masked]>
Date: Thu, 18 Sep 2014 11:06:23 +0200

On Wed, Sep 17, 2014 at 06:04:07PM -0500, Joe M wrote:
> 
> master# echo "1" | sudo tee /proc/sys/net/ipv4/ip_forward
> 1
> master# modprobe ip_vti
> master# ipsec start
> Starting strongSwan 5.2.0 IPsec [starter]...
> master# ip tunnel add vtil mode vti local 192.168.0.11 remote
> 192.168.1.232 ikey 1 okey 1
> master# ip link set vtil up
> master# sleep 60
> master# ip route add 192.168.1.0/24 dev vtil
> master# ip xfrm state
> src 192.168.0.11 dst <client or alice or bnglr public ip>

Not sure what <client or alice or bnglr public ip> is,
but dst must match the remote tunnel endpoint i.e.
192.168.1.232 in your case.