Subject: Re: [PATCH 00/22] net: phy: refactoring and Micrel features

From: Johan Hovold <[email-masked]>
Date: Tue, 11 Nov 2014 19:00:24 +0100

On Tue, Nov 11, 2014 at 12:49:36PM -0500, David Miller wrote:
> 22 patches is just too much, sorry.
> 
> Please reduce this down to something closer to ~10 or so patches.
> 
> If necessary you can do two series, submit the first 10 and then
> when that's reviewed and accepted submit the second set.

No problem. The three driver-registration patches are really
self-contained and could be reviewed and applied separately, and then I
split the remaining ones where I add the device-type abstraction, that
is:

Series 1:
  net: phy: add module_phy_driver macro
  net: phy: replace phy_driver_register calls
  net: phy: replace phy_drivers_register calls

Series 2:
  dt/bindings: fix documentation of ethernet-phy compatible property
  net: phy: micrel: fix config_intr error handling
  net: phy: micrel: use BIT macro
  net: phy: micrel: refactor broadcast disable
  net: phy: micrel: disable broadcast for KSZ8081/KSZ8091
  net: phy: micrel: add led-mode sanity check
  net: phy: micrel: refactor led-mode error handling
  net: phy: micrel: clean up led-mode setup
  net: phy: micrel: enable led-mode for KSZ8081/KSZ8091

Series 3 (submitted after review of Series 2):
  net: phy: add static data field to struct phy_driver
  net: phy: micrel: add device-type abstraction
  net: phy: micrel: parse of nodes at probe
  net: phy: micrel: add has-broadcast-disable flag to type data
  net: phy: micrel: add generic rmii-ref-clk-sel support
  net: phy: micrel: add support for rmii_ref_clk_sel to KSZ8081/KSZ8091
  dt/bindings: add micrel,rmii_ref_clk_sel_25_mhz to eth-phy binding
  net: phy: micrel: refactor interrupt config
  net: phy: micrel: add copyright entry
  net: phy: micrel: use generic config_init for KSZ8021/KSZ8031

Thanks,
Johan