Subject: Re: [PATCH v4] wcn36xx: Set default BTLE coexistence config

From: Bjorn Andersson <[email-masked]>
Date: Thu, 16 Nov 2017 10:36:18 -0800

On Thu 16 Nov 00:01 PST 2017, Ramon Fried wrote:

> From: Eyal Ilsar <[email-masked]>
> 
> If the value for the firmware configuration parameters
> BTC_STATIC_LEN_LE_BT and BTC_STATIC_LEN_LE_WLAN are not set the duty
> cycle between BT and WLAN is such that if BT (including BLE) is active
> WLAN gets 0 bandwidth. When tuning these parameters having a too high
> value for WLAN means that BLE performance degrades.
> The "sweet" point of roughly half of the maximal values was empirically
> found to achieve a balance between BLE and Wi-Fi coexistence
> performance.
> 
> Signed-off-by: Eyal Ilsar <[email-masked]>
> Signed-off-by: Ramon Fried <[email-masked]>

Looks good,

Acked-by: Bjorn Andersson <[email-masked]>

Regards,
Bjorn

> ---
>  drivers/net/wireless/ath/wcn36xx/smd.c | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/drivers/net/wireless/ath/wcn36xx/smd.c b/drivers/net/wireless/ath/wcn36xx/smd.c
> index 9c6590d5348a..6f1e741acf3e 100644
> --- a/drivers/net/wireless/ath/wcn36xx/smd.c
> +++ b/drivers/net/wireless/ath/wcn36xx/smd.c
> @@ -73,6 +73,8 @@ static struct wcn36xx_cfg_val wcn36xx_cfg_vals[] = {
>  	WCN36XX_CFG_VAL(TX_PWR_CTRL_ENABLE, 1),
>  	WCN36XX_CFG_VAL(ENABLE_CLOSE_LOOP, 1),
>  	WCN36XX_CFG_VAL(ENABLE_LPWR_IMG_TRANSITION, 0),
> +	WCN36XX_CFG_VAL(BTC_STATIC_LEN_LE_BT, 120000),
> +	WCN36XX_CFG_VAL(BTC_STATIC_LEN_LE_WLAN, 30000),
>  	WCN36XX_CFG_VAL(MAX_ASSOC_LIMIT, 10),
>  	WCN36XX_CFG_VAL(ENABLE_MCC_ADAPTIVE_SCHEDULER, 0),
>  };
> -- 
> The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
> a Linux Foundation Collaborative Project
>