Subject: Re: [PATCH] net: phy: marvell: clear wol event before setting it

From: Jisheng Zhang <[email-masked]>
Date: Thu, 26 Apr 2018 14:15:08 +0800

Hi,

On Thu, 26 Apr 2018 11:10:21 +0530 Bhadram Varka wrote:

> Hi,
> 
> On 4/19/2018 5:48 PM, Andrew Lunn wrote:
> > On Thu, Apr 19, 2018 at 04:02:32PM +0800, Jisheng Zhang wrote:  
> >> From: Jingju Hou <[email-masked]>
> >>
> >> If WOL event happened once, the LED[2] interrupt pin will not be
> >> cleared unless reading the CSISR register. So clear the WOL event
> >> before enabling it.
> >>
> >> Signed-off-by: Jingju Hou <[email-masked]>
> >> Signed-off-by: Jisheng Zhang <[email-masked]>
> >> ---
> >>   drivers/net/phy/marvell.c | 9 +++++++++
> >>   1 file changed, 9 insertions(+)
> >>
> >> diff --git a/drivers/net/phy/marvell.c b/drivers/net/phy/marvell.c
> >> index c22e8e383247..b6abe1cbc84b 100644
> >> --- a/drivers/net/phy/marvell.c
> >> +++ b/drivers/net/phy/marvell.c
> >> @@ -115,6 +115,9 @@
> >>   /* WOL Event Interrupt Enable */
> >>   #define MII_88E1318S_PHY_CSIER_WOL_EIE			BIT(7)
> >>   
> >> +/* Copper Specific Interrupt Status Register */
> >> +#define MII_88E1318S_PHY_CSISR				0x13
> >> +
> >>   /* LED Timer Control Register */
> >>   #define MII_88E1318S_PHY_LED_TCR			0x12
> >>   #define MII_88E1318S_PHY_LED_TCR_FORCE_INT		BIT(15)
> >> @@ -1393,6 +1396,12 @@ static int m88e1318_set_wol(struct phy_device *phydev,
> >>   		if (err < 0)
> >>   			goto error;
> >>   
> >> +		/* If WOL event happened once, the LED[2] interrupt pin
> >> +		 * will not be cleared unless reading the CSISR register.
> >> +		 * So clear the WOL event first before enabling it.
> >> +		 */
> >> +		phy_read(phydev, MII_88E1318S_PHY_CSISR);
> >> +  
> > Hi Jisheng
> >
> > The problem with this is, you could be clearing a real interrupt, link
> > down/up etc. If interrupts are in use, i think the normal interrupt
> > handling will clear the WOL interrupt? So can you make this read
> > conditional on !phy_interrupt_is_valid()?  
> So this will clear WoL interrupt bit from Copper Interrupt status register.
> 
> How about clearing WoL status (Page 17, register 17) for every WOL event ?
> 

This is already properly done by setting MII_88E1318S_PHY_WOL_CTRL_CLEAR_WOL_STATUS
in m88e1318_set_wol()

Thanks