Subject: [net-next PATCH v2 3/5] net: dsa: qca8k: limit user ports access to the first CPU port on setup

From: Christian Marangi <[email-masked]>
Date: Sat, 29 Jul 2023 13:55:07 +0200

In preparation for multi-CPU support, set CPU port LOOKUP MEMBER outside
the port loop and setup the LOOKUP MEMBER mask for user ports only to
the first CPU port.

This is to handle flooding condition where every CPU port is set as
target and prevent packet duplication for unknown frames from user ports.

Secondary CPU port LOOKUP MEMBER mask will be setup later when
port_change_master will be implemented.

Signed-off-by: Christian Marangi <[email-masked]>
Reviewed-by: Simon Horman <[email-masked]>
Reviewed-by: Florian Fainelli <[email-masked]>
Reviewed-by: Vladimir Oltean <[email-masked]>
---
 drivers/net/dsa/qca/qca8k-8xxx.c | 14 ++++++--------
 1 file changed, 6 insertions(+), 8 deletions(-)

diff --git a/drivers/net/dsa/qca/qca8k-8xxx.c b/drivers/net/dsa/qca/qca8k-8xxx.c
index 31552853fdd4..6286a64a2fe3 100644
--- a/drivers/net/dsa/qca/qca8k-8xxx.c
+++ b/drivers/net/dsa/qca/qca8k-8xxx.c
@@ -1850,18 +1850,16 @@ qca8k_setup(struct dsa_switch *ds)
 	if (ret)
 		return ret;
 
+	/* CPU port gets connected to all user ports of the switch */
+	ret = qca8k_rmw(priv, QCA8K_PORT_LOOKUP_CTRL(cpu_port),
+			QCA8K_PORT_LOOKUP_MEMBER, dsa_user_ports(ds));
+	if (ret)
+		return ret;
+
 	/* Setup connection between CPU port & user ports
 	 * Configure specific switch configuration for ports
 	 */
 	for (i = 0; i < QCA8K_NUM_PORTS; i++) {
-		/* CPU port gets connected to all user ports of the switch */
-		if (dsa_is_cpu_port(ds, i)) {
-			ret = qca8k_rmw(priv, QCA8K_PORT_LOOKUP_CTRL(i),
-					QCA8K_PORT_LOOKUP_MEMBER, dsa_user_ports(ds));
-			if (ret)
-				return ret;
-		}
-
 		/* Individual user ports get connected to CPU port only */
 		if (dsa_is_user_port(ds, i)) {
 			ret = qca8k_rmw(priv, QCA8K_PORT_LOOKUP_CTRL(i),
-- 
2.40.1