Subject: Re: [PATCH net-next v8 5/7] net: phy: nxp-c45-tja11xx: add MACsec support

From: Simon Horman <[email-masked]>
Date: Sat, 4 Nov 2023 11:35:06 +0000

On Mon, Oct 23, 2023 at 12:43:25PM +0300, Radu Pirea (NXP OSS) wrote:
> Add MACsec support.
> The MACsec block has four TX SCs and four RX SCs. The driver supports up
> to four SecY. Each SecY with one TX SC and one RX SC.
> The RX SCs can have two keys, key A and key B, written in hardware and
> enabled at the same time.
> The TX SCs can have two keys written in hardware, but only one can be
> active at a given time.
> On TX, the SC is selected using the MAC source address. Due of this
> selection mechanism, each offloaded netdev must have a unique MAC
> address.
> On RX, the SC is selected by SCI(found in SecTAG or calculated using MAC
> SA), or using RX SC 0 as implicit.
> 
> Signed-off-by: Radu Pirea (NXP OSS) <[email-masked]>

...

> +void nxp_c45_handle_macsec_interrupt(struct phy_device *phydev,
> +				     irqreturn_t *ret)
> +{
> +	struct nxp_c45_phy *priv = phydev->priv;
> +	struct nxp_c45_secy *pos, *tmp;
> +	struct nxp_c45_sa *sa;
> +	u8 encoding_sa;
> +	int secy_id;
> +	u32 reg = 0;
> +
> +	if (!priv->macsec)
> +		return;
> +
> +	do {
> +		nxp_c45_macsec_read(phydev, MACSEC_EVR, &reg);
> +		if (!reg)
> +			return;
> +
> +		secy_id = MACSEC_REG_SIZE - ffs(reg);
> +		list_for_each_entry_safe(pos, tmp, &priv->macsec->secy_list,
> +					 list)
> +			if (pos->secy_id == secy_id)
> +				break;
> +
> +		encoding_sa = pos->secy->tx_sc.encoding_sa;

Hi Radu,

I'm unsure if this can happen, but my understanding is that if
priv->macsec->secy_list is empty then pos will be uninitialised here.

Flagged by Coccinelle.

> +		phydev_dbg(phydev, "pn_wrapped: TX SC %d, encoding_sa %u\n",
> +			   pos->secy_id, encoding_sa);
> +
> +		sa = nxp_c45_find_sa(&pos->sa_list, TX_SA, encoding_sa);
> +		if (!IS_ERR(sa))
> +			macsec_pn_wrapped(pos->secy, sa->sa);
> +		else
> +			WARN_ON(1);
> +
> +		nxp_c45_macsec_write(phydev, MACSEC_EVR,
> +				     TX_SC_BIT(pos->secy_id));
> +		*ret = IRQ_HANDLED;
> +	} while (reg);
> +}

...