Subject: Re: [PATCH] net: phy: marvell-88q2xxx: add driver for the Marvell 88Q2220 PHY

From: Dimitri Fedrau <[email-masked]>
Date: Sat, 16 Dec 2023 23:11:51 +0100

Am Sat, Dec 16, 2023 at 05:46:32PM +0100 schrieb Andrew Lunn:
> > +static int mv88q222x_config_aneg_gbit(struct phy_device *phydev)
> > +{
> > +	int ret;
> > +
> > +	/* send_s detection threshold, slave and master */
> > +	ret = phy_write_mmd(phydev, MDIO_MMD_AN, 0x8032, 0x2020);
> > +	if (ret < 0)
> > +		return ret;
> > +
> > +	ret = phy_write_mmd(phydev, MDIO_MMD_AN, 0x8031, 0xa28);
> > +	if (ret < 0)
> > +		return ret;
> > +
> > +	ret = phy_write_mmd(phydev, MDIO_MMD_AN, 0x8031, 0xc28);
> > +	if (ret < 0)
> > +		return ret;
> 
> Same register with two different values?
>
Just copied the init sequence from sample code provided by Marvell.
I don't know if its a mistake. There is no documentation on this.

> There are a lot of magic values here. Does the datasheet names these
> registers? Does it define the bits? Adding #defines would be good.
> 
Datasheet is not naming them. I once asked Marvell Support for
documentation on the init sequence and what purpose each register has.
Just got the answer to use the sample code as it is.

> > +static int mv88q222x_config_aneg_preinit(struct phy_device *phydev)
> > +{
> > +	int ret, val, i;
> > +
> > +	/* Enable txdac */
> > +	ret = phy_write_mmd(phydev, MDIO_MMD_PCS, 0x8033, 0x6801);
> > +	if (ret < 0)
> > +		return ret;
> > +
> > +	/* Disable ANEG */
> > +	ret = phy_write_mmd(phydev, MDIO_MMD_AN, MDIO_AN_T1_CTRL, 0x0);
> > +	if (ret < 0)
> > +		return ret;
> > +
> > +	/* Set IEEE power down */
> > +	ret = phy_write_mmd(phydev, MDIO_MMD_PMAPMD, MDIO_CTRL1, 0x840);
> 
> 0x800 is MDIO_CTRL1_LPOWER. What is the other? It seems like a speed
> selection bit?
>
The other is MDIO_PMA_CTRL1_SPEED1000. Will fix this in V2.

> 	  Andrew