Subject: Re: [PATCH net-next v3 1/3] dt-bindings: net: ethernet-phy: add property tx-amplitude-100base-tx-percent

From: Dimitri Fedrau <[email-masked]>
Date: Wed, 5 Feb 2025 05:43:49 +0100

Am Tue, Feb 04, 2025 at 08:28:09AM -0600 schrieb Rob Herring (Arm):
> 
> On Tue, 04 Feb 2025 14:09:15 +0100, Dimitri Fedrau wrote:
> > Add property tx-amplitude-100base-tx-percent in the device tree bindings
> > for configuring the tx amplitude of 100BASE-TX PHYs. Modifying it can be
> > necessary to compensate losses on the PCB and connector, so the voltages
> > measured on the RJ45 pins are conforming.
> > 
> > Signed-off-by: Dimitri Fedrau <[email-masked]>
> > ---
> >  Documentation/devicetree/bindings/net/ethernet-phy.yaml | 7 +++++++
> >  1 file changed, 7 insertions(+)
> > 
> 
> My bot found errors running 'make dt_binding_check' on your patch:
> 
> yamllint warnings/errors:
> 
> dtschema/dtc warnings/errors:
> /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/ethernet-phy.yaml: properties:tx-amplitude-100base-tx-percent: '$ref' should not be valid under {'const': '$ref'}
> 	hint: Standard unit suffix properties don't need a type $ref
> 	from schema $id: http://devicetree.org/meta-schemas/core.yaml#
> 
> doc reference errors (make refcheckdocs):
> 
> See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/[email-masked]
> 
> The base for the series is generally the latest rc1. A different dependency
> should be noted in *this* patch.
> 
> If you already ran 'make dt_binding_check' and didn't see the above
> error(s), then make sure 'yamllint' is installed and dt-schema is up to
> date:
> 
> pip3 install dtschema --upgrade
> 
> Please check and re-submit after running the above command yourself. Note
> that DT_SCHEMA_FILES can be set to your schema file to speed up checking
> your schema. However, it must be unset to test all examples with your schema.
>
Thanks, missed to check. Will fix it.

Best regards,
Dimitri Fedrau