Subject: Re: [PATCH 1/2] net: phy: marvell-88q2xxx: Enable temperature measurement in probe again

From: Dimitri Fedrau <[email-masked]>
Date: Wed, 19 Feb 2025 11:46:47 +0100

Hi Stefan,

thanks for reviewing.

Am Wed, Feb 19, 2025 at 07:16:58AM +0100 schrieb Stefan Eichenberger:
> Hi Dimitri,
> 
> On Tue, Feb 18, 2025 at 07:33:09PM +0100, Dimitri Fedrau wrote:
> > Enabling of the temperature sensor was moved from mv88q2xxx_hwmon_probe to
> > mv88q222x_config_init with the consequence that the sensor is only
> > usable when the PHY is configured. Enable the sensor in
> > mv88q2xxx_hwmon_probe as well to fix this.
> > 
> > Fixes: a197004cf3c2 ("net: phy: marvell-88q2xxx: Fix temperature measurement with reset-gpios")
> > Signed-off-by: Dimitri Fedrau <[email-masked]>
> > ---
> >  drivers/net/phy/marvell-88q2xxx.c | 7 +++++++
> >  1 file changed, 7 insertions(+)
> > 
> > diff --git a/drivers/net/phy/marvell-88q2xxx.c b/drivers/net/phy/marvell-88q2xxx.c
> > index a3996471a1c9a5d4060d5d19ce44aa70e902a83f..30d71bfc365597d77c34c48f05390db9d63c4af4 100644
> > --- a/drivers/net/phy/marvell-88q2xxx.c
> > +++ b/drivers/net/phy/marvell-88q2xxx.c
> > @@ -718,6 +718,13 @@ static int mv88q2xxx_hwmon_probe(struct phy_device *phydev)
> >  	struct device *dev = &phydev->mdio.dev;
> >  	struct device *hwmon;
> >  	char *hwmon_name;
> > +	int ret;
> > +
> > +	/* Enable temperature sense */
> > +	ret = phy_modify_mmd(phydev, MDIO_MMD_PCS, MDIO_MMD_PCS_MV_TEMP_SENSOR2,
> > +			     MDIO_MMD_PCS_MV_TEMP_SENSOR2_DIS_MASK, 0);
> > +	if (ret < 0)
> > +		return ret;
> >  
> >  	priv->enable_temp = true;
> >  	hwmon_name = devm_hwmon_sanitize_name(dev, dev_name(dev));
> 
> Is it necessary to have it enabled in probe and in config? Is that
> because of the soft reset? Can it happen that the phy is reset but
> config is not called, then we would end up in the same situation right?
>
Even if the phy is not configured yet, it is probed and the PHYs hard reset
is deasserted, so I can read the temperature. I think the situation you
mean is when the PHY is brought up and down again. In this case the hard
reset of the PHY is asserted and I can't read the temperature. That's
the second patch of the series that fixes this issue.

Best regards,
Dimitri