Subject: Re: [PATCH] at91_ether: use gpio_is_valid for phy IRQ line

From: Nicolas Ferre <[email-masked]>
Date: Fri, 25 Nov 2011 14:56:01 +0100

On 11/25/2011 02:47 PM, Jean-Christophe PLAGNIOL-VILLARD :
> On 22:28 Thu 24 Nov     , Jamie Iles wrote:
>> Hi Nicolas,
>>
>> On Thu, Nov 24, 2011 at 10:21:14PM +0100, Nicolas Ferre wrote:
>>> Use the generic gpiolib gpio_is_valid() function to test
>>> if the phy IRQ line GPIO is actually provided.
>>>
>>> For non-connected or non-existing phy IRQ lines, -EINVAL
>>> value is used for phy_irq_pin field of struct at91_eth_data.
>>>
>>> Signed-off-by: Nicolas Ferre <[email-masked]>
>>> ---
>>>  drivers/net/ethernet/cadence/at91_ether.c |   23 +++++++++++++----------
>>>  1 files changed, 13 insertions(+), 10 deletions(-)
>>>
>>> diff --git a/drivers/net/ethernet/cadence/at91_ether.c b/drivers/net/ethernet/cadence/at91_ether.c
>>> index 56624d3..a1c4143 100644
>>> --- a/drivers/net/ethernet/cadence/at91_ether.c
>>> +++ b/drivers/net/ethernet/cadence/at91_ether.c
>>> @@ -255,8 +255,7 @@ static void enable_phyirq(struct net_device *dev)
>>>  	unsigned int dsintr, irq_number;
>>>  	int status;
>>>  
>>> -	irq_number = lp->board_data.phy_irq_pin;
>>> -	if (!irq_number) {
>>> +	if (!gpio_is_valid(lp->board_data.phy_irq_pin)) {
>>>  		/*
>>>  		 * PHY doesn't have an IRQ pin (RTL8201, DP83847, AC101L),
>>>  		 * or board does not have it connected.
>>> @@ -265,6 +264,7 @@ static void enable_phyirq(struct net_device *dev)
>>>  		return;
>>>  	}
>>>  
>>> +	irq_number = lp->board_data.phy_irq_pin;
>>
>> Does this need to be:
>>
>> 	irq_number = gpio_to_irq(lp->board_data.phy_irq_pin);
>>
>> and the same for the other occurrences?  Otherwise this looks like the 
>> right thing to me.
> yes

True but I prefered to separate changes. As it was not addressed like
this in the code I clung to it. I will post an additional patch on top
of this one to add the gpio_to_irq() call.

> Acked-by: Jean-Christophe PLAGNIOL-VILLARD <[email-masked]>

Best regards,
-- 
Nicolas Ferre