Subject: Re: [PATCH 11/11] net: xilinx: Show csum in bootlog

From: Michal Simek <[email-masked]>
Date: Fri, 05 Oct 2012 11:35:00 +0200

On 10/04/2012 09:15 PM, Ben Hutchings wrote:
> On Thu, 2012-10-04 at 20:14 +0200, Michal Simek wrote:
>> Just show current setting in bootlog.
> [...]
>> --- a/drivers/net/ethernet/xilinx/ll_temac_main.c
>> +++ b/drivers/net/ethernet/xilinx/ll_temac_main.c
>> @@ -1052,12 +1052,14 @@ static int __devinit temac_of_probe(struct platform_device *op)
>>   	/* Setup checksum offload, but default to off if not specified */
>>   	lp->temac_features = 0;
>>   	p = (__be32 *)of_get_property(op->dev.of_node, "xlnx,txcsum", NULL);
>> +	dev_info(&op->dev, "TX_CSUM %d\n", be32_to_cpup(p));
>>   	if (p && be32_to_cpu(*p)) {
>>   		lp->temac_features |= TEMAC_FEATURE_TX_CSUM;
>>   		/* Can checksum TCP/UDP over IPv4. */
>>   		ndev->features |= NETIF_F_IP_CSUM;
>>   	}
>>   	p = (__be32 *)of_get_property(op->dev.of_node, "xlnx,rxcsum", NULL);
>> +	dev_info(&op->dev, "RX_CSUM %d\n", be32_to_cpup(p));
> [...]
>
> Is there any particular reason you think this needs to be logged by
> default, rather than letting users run ethtool -k?  I suggest using
> dev_dbg() instead.

Ok. I have looked at it and there are missing some bits in ndev->features.

Can you please check that my setting is correct?

It is SG DMA ip/driver.
ndev->features = NETIF_F_FRAGLIST | NETIF_F_SG

With two options for csum on RX/TX. They can be selected independently.
tx Partial csum over IPv4. -> NETIF_F_IP_CSUM
tx Full csum. -> NETIF_F_HW_CSUM

rx Full csum -> NETIF_F_RXCSUM

Is there any option to support partial csum?

Thanks,
Michal

-- 
Michal Simek, Ing. (M.Eng)
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel 2.6 Microblaze Linux - http://www.monstr.eu/fdt/
Microblaze U-BOOT custodian