Subject: Re: [RFC/RFT 05/23] net: phy: Immediately call adjust_link if only tx_lpi_enabled changes

From: "Russell King (Oracle)" <[email-masked]>
Date: Mon, 27 Mar 2023 19:02:01 +0100

On Mon, Mar 27, 2023 at 07:01:43PM +0200, Andrew Lunn wrote:
> The MAC driver changes its EEE hardware configuration in its
> adjust_link callback. This is called when auto-neg completes. If
> set_eee is called with a change to tx_lpi_enabled which does not
> trigger an auto-neg, it is necessary to call the adjust_link callback
> so that the MAC is reconfigured to take this change into account.
> 
> When setting phydev->eee_active, take tx_lpi_enabled into account, so
> the MAC drivers don't need to consider tx_lpi_enabled.
> 
> Signed-off-by: Andrew Lunn <[email-masked]>

Hmm..

> @@ -1619,11 +1619,20 @@ int phy_ethtool_set_eee(struct phy_device *phydev, struct ethtool_eee *data)
>  
>  	mutex_lock(&phydev->lock);
>  	ret = genphy_c45_ethtool_set_eee(phydev, data);
> -	if (!ret)
> +	if (ret >= 0) {
> +		if (ret == 0) {
> +			/* auto-neg not triggered */
> +			if (phydev->tx_lpi_enabled != data->tx_lpi_enabled) {
> +				phydev->tx_lpi_enabled = data->tx_lpi_enabled;
> +				if (phydev->link)
> +					phy_link_up(phydev);
> +			}
> +		}
>  		phydev->tx_lpi_enabled = data->tx_lpi_enabled;

So we set eee_active depending on tx_lpi_enabled:

> +			phydev->eee_active = (err & phydev->tx_lpi_enabled);

However, if tx_lpi_enabled changes state in this function, we don't
update phydev->eee_active, but it's phydev->eee_active that gets
passed back to MAC drivers. Is that intentional?

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 40Mbps down 10Mbps up. Decent connectivity at last!